Search Results

Cremer impedance, first proposed by Cremer (Acustica 3, 1953) and then improved by Tester (JSV 28, 1973), refers to the locally reacting boundary condition that can maximize the attenuation of a certain acoustic mode in a uniform waveguide. One limitation in Tester’s work is that it simplified the analysis on the effect of flow by only considering high frequencies or the ‘well cut-on’ modes. This approximation is reasonable for large duct applications, e.g., aero-engines, but not for many other cases of interest, with the vehicle intake and exhaust system included. A recent modification done by Kabral et al. (Acta Acustica united with Acustica 102, 2016) has removed this limitation and investigated the ‘exact’ solution of Cremer impedance for circular waveguides, which reveals an appreciable difference between the exact and classic solution in the low frequency range. Consequently, the exact solution can lead to a much higher low-frequency attenuation level.

In this paper the propagation of acoustic plane waves in turbulent, fully developed flow is studied by means of an experimental investigation carried out in a straight, smooth-walled duct. The presence of a coherent perturbation, such as an acoustic wave in a turbulent confined flow, generates the oscillation of the wall shear stress. In this circumstance a shear wave is excited and superimposed on the sound wave. The turbulent shear stress is modulated by the shear wave and the wall shear stress is strongly affected by the turbulence. From the experimental point of view, it results in a measured damping strictly connected to the ratio between the thickness of the acoustic sublayer, which is frequency dependent, and the thickness of the viscous sublayer of the turbulent mean flow, the last one being dependent on the Mach number. By reducing the turbulence, the viscous sublayer thickness increases and the wave propagation is mainly dominated by convective effects.

The acoustic impedance exhibited by a new type of element for noise control, the Micro-Grooved Elements (MGEs), has been widely investigated in this paper. The MGEs are typically composed of two overlying layers presenting macroscopic slots and a number of micro-grooves on one of the contact surfaces. The micro-grooves result in micro-channels as the layers are assembled to form the element. Similarly to Micro-Perforated Elements (MPEs), the MGEs have been proved to provide effective dissipation of acoustic energy by the means of viscous losses taking place in the micro-channels. However, in contrast to the MPEs, the MGEs use the grooves, instead of the holes, in which the air is forced to pass through. It results in more cost effective elements, which have been found to represent an adequate alternative for fibrous materials, typically present in silencer units.

Regulations stipulating the design of motorcycle silencers are strict, especially when the unit incorporates fibrous absorbing materials. Therefore, innovative designs substituting such materials while still preserving acceptable level of characteristic sound are currently of interest. Micro perforated elements are innovative acoustic solutions, which silencing effect is based on the dissipation of the acoustic wave energy in a pattern of sub-millimeter apertures. Similarly to fibrous materials the micro-perforated materials have been proved to provide effective sound absorption in a wide frequency range. Additionally, the silencer is designed as a two-stage system that provides an optimal solution for a variety of exploitation conditions. In this paper a novel design for a cruiser type motorcycle silencer, based on micro-perforated elements, is presented.

In this paper an overview of recent experimental studies performed at KTH on the sound transmission and sound generation in turbochargers is presented. The compressor and turbine of the turbochargers are treated as acoustic active 2-ports and characterized using the unique experimental test facility established at KTH. The 2-port model is limited to the plane wave range so for higher frequencies the propagating acoustic power is estimated using an average based on pressure cross-spectra. A number of automotive turbochargers have been studied for a variety of operating conditions systematically selected from the compressor and turbine charts. The paper discusses the experimental procedures including special techniques implemented to improve the quality of the data. Results from a number of experiments on various modern automotive turbochargers including a unit with variable turbine geometry (VTG) are presented.