Search Results

Shearography is an optical technique developed for full-field measurement of surface deformation. It has since been accepted by industry as a practical nondestructive testing technique for evaluating the structural integrity of components and structures. Qualitatively, shearography reveals flaws from flaw-induced, anomalous deformation in the component under inspection, and quantitatively, shearography assesses the detected flaws through back-calculation from the anomalous deformation. This paper demonstrates that, with the use of multiple-frequency acoustical excitation together with the time-integrated shearographic recording technique, rapid and automated assessment of the integrity of adhesive-bonded composite structures can be realized in the actual plant environment.

This paper presents an application of shearography, an optical method for full-field strain measurement, for evaluating residual stresses in plastic/composite components. The approach is based on measuring the change in slope of the component surface, which is caused by the release of residual stresses, in the vicinity of a small, shallow blind-hole or of a small indentation made on the underside of the component during testing. The severity of slope-change, and hence the fringe density, gives a measure of the residual stresses in the component. This method does not require laborious mounting of strain gages or transducers whose stiffness could affect the accuracy of measurements, and is therefore practical for use in both production and field environment.

A novel computer vision technique for rapid measurement of surface coordinates is presented. The technique is based on the marriage of a digital fringe projection technique and a fringe-phase extraction algorithm. A digitally controlled video signal in the form of linear and parallel fringes of cosinusoidal intensity variation is projected onto an object. The fringe pattern is perturbed by the three-dimensional object surface with fringe-phase containing information on the depth of the object. A phase extraction algorithm is used to determine the fringe-phase distribution, from which the three-dimensional surface coordinates are determined. The theoretical basis of this technique and some experimental results are presented in this paper.

This paper presents a novel technique allowing time-dependent displacement of an object to be studied by continuously digitizing the speckle images using a high speed image acquisition system. Instead of generating fringe patterns, the displacement versus time for any point of interest can be studied. Therefore, the technique is equivalent to “many” massless and noncontact displacement sensors, which is particularly useful for vibration measurement.

As the use of electronic devices in automobiles increases, the reliability of such devices is becoming increasingly important. One possible failure is due to leakage resulted from imperfect hermetical seal in mircochips and microelectronic packages. This paper presents an optical technique referred to as shearography for rapid evaluation of hermetics seals. The proposed process of leaking testing is very fast and practical.

This paper presents an optical method for evaluating residual stresses. The approach is based on measuring the deformation due to the relief of stress produced by a blind-hole drilling technique. The deformation is rapidly measured by shearography. Unlike the strain gage method, this method does not require mounting strain gages /transducers. A rapid process for detection of residual stress using a micro-indentation technique is also present. The method is practical for employment in a production/field environment.

An optical method for measuring surface deformation of automotive panels is presented. The technique, which is based a 3-D computer vision technique previously reported by the authors, is full-field, noncontact, simple, fast and can be automated. Theory of the technique together with experimental results are presented in the paper.

Two three-dimensional computer vision schemes will be presented, one for diffusely reflective surfaces, and the other for specularly reflective surfaces. Both techniques are based on the marriages of optical techniques and computer image processing algorithms which allow full-field precision measurement of surface depth. The techniques can also be used for inspecting surface quality of car bodies.