Search Results

Fleet tests conducted on electrical vehicles around the world have very clearly shown that battery-powered cars may be regarded as zero-emission vehicles with respect to their local environments only. Emission measurements on vehicles powered by internal-combustion engines equipped with optimized exhaust-post-treatment systems have indicated the prospects the latter offer for cleaning up the environment, i.e., for yielding negative emissions, when run at their normal operating temperatures. Replacing electric cars with SULEV's is thus a matter currently under discussion. This paper will cover the functions of the various individual components of such post-treatment systems, and will show that optimizing the interactions among those components will improve their catalytic efficiencies.

The development of the S-designed metallic catalytic converter and the flexibility of its production paved the way for the first conical converter with continuous cell enlargement. This type of conical converter, installed upstream from a standard catalytic conversion system exerts a positive influence on flow distribution and converter efficiency, both during the cold start and under operating conditions. The study results outlined in the following text demonstrate the potential for increased catalytic effectiveness, taking the example of the close-coupled application.

To meet LEV/ULEV - requirements, a considerable amount of development work was necessary to ensure suitable efficiency and durability of catalyst systems [1, 2, 3]. In addition to active emission reduction systems like the Electrically Heated Catalyst (EHC), Exhaust Gas Ignition (EGI) and the burner, passive systems like the HC-trap and Closed-Coupled Catalysts (CCC) are practical solutions to fulfill tighter emission requirements [4, 5, 6, 7]. Depending on the application, thermo-mechanical stresses, vibrations and efficiency degradation through aging increases with the reduction of the distance between the engine and the catalytic converter. Therefore, the test procedures which were suitable for converters which were to be placed in underfloor positions, needed to be modified according to the load spectra acting on close-coupled catalysts. This paper describes a new test strategy used during the development and design verification phase of catalytic converter systems.

From SAE-Papers and several publications, the easy, effective function and management of an EHC-System is well known. The direction of the development is now to reduce the electrical energy consumption and to show the mechanical durability of the heating structure. This paper shows that it is possible to minimize the energy consumption and that the required service life can be in principle achieved with the introduction of these developments. The physical characteristics such as mass, geometrical surface area, cell density and electrical resistance of the EHC construction could be optimized to save energy. This, in conjunction with the operating parameters of the engine, the controlling of the secondary air and the catalyst configuration, will enable the goals to be met. The design of the converter, the physical characteristics and the results of the tests are shown with the Porsche 944 S2 and 968 applications.

Metal supported catalysts, whose early development actually started in the sixties, are used today in a few isolated cases as starter catalysts, retrofit and underfloor catalysts of small dimensions. The new Porsche Carrera 4 is the first production car to use a large main catalytic converter with metal supports. This paper describes the design of this catalyst and the advantages of using the metal supports, especially the increase in power output due to the reduction of exhaust back pressure. Also benefits in catalytic performance could be determined. The major requirement in using large metal supports in production is mechanical sturdiness. In extensive vehicle, test bench and laboratory tests and according to the theoretical calculations, the support with S-design described here has met this requirement.