Search Results

Heating neat (100 percent) methanol fuel (M100) is shown to improve dramatically the atomization of the fuel from a production, automotive, port fuel injector of pintle design. This improvement is particularly noticeable and important when compared with atomization at low fuel temperatures, corresponding to those conditions where cold-start is a significant problem with neat methanol-fueled (M100) vehicles. The improved atomization is demonstrated with photographs and laser-diffraction measurements of the drop-size distributions. Fuel temperatures were varied from -34°C (-29°F to 117°C (243°F), while the boiling point of methanol is 64.7°C (148.5°F). Air temperatures were ambient at about 24°C (75°F). For temperatures above the boiling point, some flash boiling and vaporization were presumably occurring, and these may have contributed to the atomization, but the trends for drop size did not shown any discontinuity near the boiling point.

An extensive literature search was conducted and potential additive candidates were identified to improve the safety aspects associated with the use of methanol as a motor fuel. Before any laboratory measurements were conducted, candidate additives were evaluated for possible formation of known or suspected toxic compounds as combustion products. The remaining potential additives were then screened for their effectiveness in improving methanol fuel properties in a laboratory test program emphasizing flame luminosity, lubricity, and flammability. Flame luminosity was measured with a specially designed system to monitor the light produced by the flame in lux. Lubricity was measured with a Ball-on-Cylinder Lubricity Evaluator (BOCLE). For flammability limits, a device was designed to determine the presence of flammable vapors above the liquid at different additive concentrations.

Four major coal fuel projects which were performed at Southwest Research Institute over the past ten years are reviewed. Beginning with the “Alternative Fuels for Highway Utilization” project in 1979, and the success of carbon-black/diesel fuel slurries, the development of the coal slurries is traced to the current technology. Most recently, full-scale locomotive engines have been operated on 50% coal in water slurries at thermal efficiencies approaching that of diesel fuel performance. The paper is concluded with a recommended engine design for coal slurries.