Search Results

Operation of flex fuel vehicles requires operation with a range of fuel properties. The significant differences in the heat of vaporization and energy density of E0-E100 fuels and the effect on spray development need to be fully comprehended when developing engine control strategies. Limited enthalpy for fuel vaporization needs to be accounted for when developing injection strategies for cold start, homogeneous and stratified operation. Spray imaging of multi-hole gasoline injectors with fuels ranging from E0 to E100 and environmental conditions that represent engine operating points from ambient cold start to hot conditions was performed in a spray chamber. Schlieren visualization technique was used to characterize the sprays and the results were compared with Laser Mie scattering and Back-lighting technique. Open chamber experiments were utilized to provide input and validation of a CFD model.

A turbocharged 2.0L 4-cylinder direct injection spark ignition (DISI) engine designed for use with gasoline is simulated using one dimensional engine simulation. Engine design modifications - increased compression ratio, 2-step valve train with dual independent cam phasing and fuel injection timing - are considered in an effort to improve fuel economy with gasoline and take advantage of properties of ethanol fuel blends (up to E85). This paper discusses a methodology to use the simulation to quantitatively evaluate the design modification effects on fuel economy. Fuel consumption predictions from the simulation for each design are evaluated. The goal is to identify the best design with the constraints of hardware physical limitations, engine residual tolerance and knock tolerance. The result yields a specification for a 2-step valve train design and phasing requirements that can improve fuel economy for each compression ratio design.

Ethanol offers significant potential for increasing the compression ratio of SI engines resulting from its high octane number and high latent heat of vaporization. A study was conducted to determine the knock-limited compression ratio of ethanol-gasoline blends to identify the potential for improved operating efficiency. To operate an SI engine in a flex fuel vehicle requires operating strategies that allow operation on a broad range of fuels from gasoline to E85. Since gasoline or low ethanol blend operation is inherently limited by knock at high loads, strategies must be identified which allow operation on these fuels with minimal fuel economy or power density tradeoffs. A single-cylinder direct-injection spark-ignited engine with fully variable hydraulic valve actuation (HVA) is operated at WOT and other high-load conditions to determine the knock-limited compression ratio (CR) of ethanol fuel blends. The geometric CR is varied by changing pistons, producing CR from 9.2 to 12.87.

Advances in extrusion die technology allow ceramic substrate suppliers to provide new monolithic automotive substrates with considerably higher cell densities and thinner wall thicknesses. These new substrates offer both faster light off and better steady state efficiencies providing new flexibility in the design of automotive catalytic converters. The effectiveness-NTU methodology is used to evaluate various design parameters of the HCD substrates. Various theoretical derivations are supported with experimental results on substrates with cell densities ranging from 400 to 1200 cells per square inch with varying wall thicknesses. Performance effects such as steady state conversion, transient response both thermal and emission, flow restriction and FTP emissions results are evaluated. Poison deposition is studied and the effects on emissions performance evaluated.

Catalytic converters are a primary component of an automotive emissions control system used to control exhaust emissions to the low levels required by current regulations. During cold starts, the converter is ineffective until it reaches a lightoff temperature of approximately 3500 C. During this time 50% to 80% of the regulated hydrocarbon and carbon monoxide emissions are emitted from the tailpipe. To reduce these cold start emissions to meet the more stringent emission standards required by the Revised Clean Air Act of 1990 and the more restrictive California emissions standards, the catalytic converter must be heated quickly to lightoff temperature. Conservation of exhaust thermal energy is one of several approaches being studied to quicken lightoff. Much thermal energy is available in the gases leaving the combustion chamber with temperatures exceeding 350°C following engine ignition.