Search Results

Previous studies on the effect of Mg on the hardness of 319-type alloys are contradictory. The present study was conducted in an attempt to resolve this confusion and allow for a more rational choice of Mg concentration specifications. Four 319-type alloys were prepared with the following target Mg concentrations: 0.00, 0.15, 0.35 and 0.45 wt%. The addition of only 0.15 wt% Mg had a significant effect on the hardness of the alloy but further incremental additions of Mg did not produce the expected trends in hardness. Two hypotheses for this unexplained behavior are presented. This work suggests that the Mg concentration can be allowed to vary between 0.15 wt% and 0.45 wt% without significantly impacting the aging response (hardness) of the alloy.

Gas carburized and quenched low alloy steels typically produce surface microstructures which contain martensite, retained austenite and often NMTP's (non-martensitic transformation products). The NMTP's are caused by a reduction of surface hardenability in the carburizing process from loss of alloying elements to oxidation. Gas carburized low alloy steels such as SAE 8620 with NMTP's on the surface have been shown to have inferior bending fatigue properties when compared to more highly alloyed steels which do not form NMTP's, such as SAE 4615M. One method of minimizing the formation of oxides and eliminating NMTP formation during carburizing and quenching is to use plasma carburizing instead of conventional gas carburizing. In this study the microstructures and bending fatigue performance of plasma carburized SAE 8620 and SAE 4615M is compared to the same alloys conventionally gas carburized and quenched.