Search Results

The noise emission of cruising vehicles essentially consists of tire/road noise, drivetrain noise (engine with intake and exhaust system, transmission and driving axle) and aerodynamic noise due to the flow around bodywork, chassis, wheels and cooling air flow (fan). Engines and drivetrains have become quieter due to many man-years of engineering attention and tire noise has also been reduced - at least the noise reaching the passenger compartment. Consequently, the aerodynamic noise of ground vehicles has become dominant at driving speeds above 100 kph both in interior and exterior noise. In order to determine the contribution of aerodynamic noise to the overall noise, measurements are carried out more and more in specially equipped automotive wind tunnels.

A real-time 3-dimensional, nonlinear simulator for the dynamical behaviour of trucks has been developed. The simulator serves as industrial test stand for examinations on different electronic control systems. This paper describes the challenging task of developing a powerful real-time simulator with hardware coupling based on parallel transputer systems. The integration of an anti-lock braking system (ABS) as hardware-in-the-loop by means of an interface electronic device is described. The interface electronics provide the coupling of the electronic control unit (ECU). The special demands on the signals and the resulting concept for the developed electronic interface are specified. Some results from dynamic braking simulations show the quality of the simulator.

A numerical simulation program for the design of the cooling air duct and the cooling system of vehicles for stationary operating conditions is introduced. This program allows the simulation of interactions with the system environment resp. an air conditioning. Hot recirculations of air in the front part of the car and the inhomogenious flow through the heat exchangers radiator and condensor in their affects on the heat transfer capacity are simulated. The power demand of the fan, the water pump and the compressor is taken into account for calculating the heat flow from the engine into the cooling water.

The statically indeterminate supported crankshaft system (with several degrees of redundancy) in multi-cylinder combustion engines moves in the main bearings due to the gas and inertia forces acting on it. The sometimes very rapid changes in movement of the individual main bearing journals lead to impulsive force excitations, which act via the lubrication film on the main bearings, generating vibration in the main bearing lane. In order to clarify these relationships, experiments have been carried out on a gasoline engine, whereby, in addition to combustion chamber pressure, recordings are also made of the movements (journal orbits) of all main bearing journals and of the vibration excitation at the main bearing caps.