Refine Your Search

Search Results

Author:
Viewing 1 to 4 of 4
Technical Paper

The Evaluation of Oxidation Catalysts for Diesel Trucks

1995-02-01
950157
The Thermogravimetry SOF measurement method is developed as simple and time-saving method. It is experimentally revealed that this method is useful for SOF measurement and the method has potential to distinguish SOF component. The oxidation catalysts can effectively reduce particulate matter under actual driving conditions. Sulfate formation suppressing oxidation catalyst reduces high molecular number paraffins. However, it is important for further development of oxidation catalyst to improve the oxidation ability of polar hydrocarbons included in SOF. The oxidation catalysts can effectively reduce CO, HC emissions under actual driving conditions. This is caused by the temperature rise of oxidation catalysts during accelerations.
Technical Paper

The Emission of PAH from a DI Diesel Engine Operating on Fuels and Lubricants with Known PAH Content

1994-03-01
940342
Engine experiments were carried out in order to investigate the mechanisms involved in connection with the emission of lubricant related polyaromatic hydrocarbons (PAH) from a D.I. diesel engine. In the experiments only the mechanisms related to pyrene emissions were investigated, since synthetic fuels and lubricants containing pyrene as the only aromatic compond were used. Particulate matter (PM) and the soluble organic fraction (SOF) of PM as well as PAH emissions were measured for different engine conditions at different levels of pyrene in the lubricant and the fuel. Possible mechanisms of PAH transportation from the lubricant to the exhaust gas are discussed based on the experimental results, as well as the importance of fuel and lubricant to SOF and PAH emissions.
Technical Paper

Study on Regeneration of Diesel Particle Trapper by Electrical Self-Heating Type Filter

1992-02-01
920140
The cordierite filter has been widely studied because of it's inherent, high capacities in the collection efficiency and heat-resistance. During the regeneration process of a cordierite filter, failure of ignition or incomplete burning propagation occurs, and additionally melts or cracks develop sometimes. In this study, the problems stated above are considered from a new standpoint, and a regeneration method that does not strictly depend on accumulated soot quantity is discussed. A filter made of SiC (Silicon carbide) possesses the requisite electric resistance and it's possible to heat it uniformly by using electricity. Accumulated soot can be uniformly incinerated not by burning propagation but by simultaneous ignition and burning of all accumulated soot. Silicon carbide has a higher resistance to heat than cordierite. Therefore, a self-heating filter made of SiC makes it possible to regenerate the filter in a wider range of accumulated soot.
Technical Paper

Particulate Matter Emission Characteristics under Transient Pattern Drivings

1989-02-01
890468
Real-time and simultaneous measurements of particulate matter emissions (PME) under transient engine operating conditions have been carried out by several methods under 20 kinds of actual speed pattern driving schedules, and frequencies of each engine speed and load zone used for individual driving schedules at different laden weight are statistically analysed. On the other hand, PME are also estimated and compared with PME characteristics under steady engine operations. Applying these data, technical possibilities to replace comprehensive driving conditions of actual speed patterns with series of steady engine operating conditions and to obtain equivalent PME are studied. As a result of the study, it has been verified through the experiments that the three-point steady-state operations can yield nearly identical PME characteristics (g/test) to those of transient speed pattern operations, by using time-averaged values of the used engine speed and load.
X