Search Results

In API engine oil licensing, candidate oils must meet the performance requirements of category defined engine tests. While API category engine tests are developed to target a theoretical performance standard, it is rare that the cost to test and approve oils is understood. Given that engine tests are an integral part of oil evaluation, understanding of engine test value is necessary. Therefore, measurements of value are presented as Unbiased Engine Test Evaluation (UETE). UETE evaluates an engine test's draw on time and money resources by estimating the average number of tests required before a candidate oil will pass the category defined engine tests. A pilot study using the API CH-4 Category is presented.

A 100-hour engine dynamometer test for intake valve deposits (IVD) which uses a Ford 2.3L engine was developed by the Coordinating Research Council (CRC). Recently, this test has been approved by the American Society for Testing and Materials (ASTM) as Test Method D 6201-97. Since this test offers improvements in test variability, duration, and cost, it is expected to replace ASTM D 5500-94, a 16,000-km vehicle test run using a BMW 318i, as the key performance test for the Certification of Gasoline Deposit Control Additives by the EPA Final Rule. As a step in the replacement process, a correlation between valve deposit levels for the CRC 2.3L Ford IVD test and ASTM D 5500 BMW IVD test must be determined. This paper provides a statistical review of available data in an attempt to provide such a correlation.

In response to industry demands for a method to qualify fuels for their intake valve deposit (IVD) forming tendencies, the Coordinating Research Council (CRC) has developed an engine dynamometer test procedure. In Phase I, the 2.3L Ford engine was chosen as the focus test engine in comparison testing with two other high volume U.S. manufactured engines.1* A two-mode dynamometer test was developed in Phases II-A & II-B and shown to discriminate among the test fuels at a 95% confidence level.2 In Phase III, both an interlaboratory study (ILS) of the two-mode dynamometer test and a vehicle fleet study were performed. The ILS was conducted to determine the repeatability and reproducibility of the test procedure and also to fulfill requirements for consideration of the test as an American Society for Testing and Materials (ASTM) standard.