Search Results

Standard

EG-1 AEROSPACE PROPULSION SYSTEMS SUPPORT EQUIPMENT CHARTER

2023-09-11

WIP

CHARTER

The purpose of this document is to supplement, and is subordinate to, the S.A.E. Technical Standards Board Governance Policy (TSBGP) and the Aerospace Council Organization and Operating Procedures (ACOOP), which set forth the organization, objectives and operating procedures for the SAE’s Committees.

Standard

Inspection of Worn Involute Splines

2020-02-03

CURRENT

ARP1111A

This concept for measuring worn splines provides a direct wear depth dimension by utilizing the unworn involute surface as a contact point from which to measure the depth of wear on the spline tooth at the pitch diameter. Fig. 1 shows spline wear patterns and pitch diameter gaging points.

Standard

Storage, Use, and Care of Borescopes and Fibrescopes (Flexible Borescopes)

2013-05-16

CURRENT

ARP4078B

This aerospace recommended practice (ARP) addresses the care, use, and training required to employ an effective borescope inspection program. Five subsections are included that cover training, storage, preoperational inspections, operation, and postoperational care related to both rigid and flexible borescopes. Throughout this ARP, proper borescope system nomenclature and terminology are utilized as specified in SAE ARP4022, Borescope Inspection System Definitions.

Standard

Involute Splines; Wear Limit, Definition Of

2000-01-01

CURRENT

ARP1200A

To provide a recommended practice covering the method criteria for defining 'wear limit' on involute splines. This recommended practice is applicable to all involute splines used in Aerospace Propulsion Units.

Standard

STORAGE, USE, AND CARE OF BORESCOPES AND FIBRESCOPES (FLEXIBLE BORESCOPES)

1997-03-01

HISTORICAL

ARP4078A

This aerospace recommended practice (ARP) addresses the care, use, and training required to employ an effective borescope inspection program. Five subsections are included that cover training, storage, preoperational inspections, operation, and postoperational care related to both rigid and flexible borescopes. Throughout this ARP, proper borescope system nomenclature and terminology are utilized as specified in SAE ARP4022, Borescope Inspection System Definitions.

Standard

INVOLUTE SPLINES; WEAR LIMIT, DEFINITION OF

1994-09-01

HISTORICAL

ARP1200

This recommended practice is applicable to all involute splines used in Aerospace Propulsion Units.

Standard

Methods for Determining Turbine Engine Nozzle Area

1989-06-01

CURRENT

AIR1627

Standard

STORAGE, USE, AND CARE OF BORESCOPES AND FIBRESCOPES (FLEXIBLE BORESCOPES)

1989-01-18

HISTORICAL

ARP4078

Standard

INSPECTION OF WORN INVOLUTE SPLINES

1984-02-01

HISTORICAL

ARP1111

This concept for measuring worn splines provides a direct wear depth dimension by utilizing the unworn involute surface as a contact point from which to measure the depth of wear on the spline tooth at the pitch diameter. Fig. 1 shows spline wear patterns and pitch diameter gaging points.

Standard

Conventional Representation

1959-11-15

CURRENT

ARP591

Conventional Representation provides established drafting practice for showing various common part elements which are a compromise between complete pictorial representation and complete symbolization. The use of conventional representation materially reduces drafting time and thus increases drafting economy without impairing the clarity of the drawing.