Refine Your Search

Date

Date

Topic

Topic

Search Results

Viewing 21 to 40 of 251
<< First< Previous1234Next >Last >>
Sort by relevance
Standard

Inspection Material, Penetrant
2021-04-30
WIP
AMS2644J
This specification establishes the classification, technical requirements, tests, and test procedures for the qualification, approval, and quality verification of all materials used in the liquid penetrant methods of inspection with the exception of those excluded in the application section.
Standard

Nondestructive Inspection Program Requirements for Aerospace Systems
2020-12-10
HISTORICAL
AS6870
This SAE Aerospace Standard defines the requirements for establishing a Nondestructive Inspection (NDI) program for aerospace systems to include but not not be limited to aircraft structure, aircraft stores (external structures such as antennas, pods, fuel tanks, weapons, radomes, etc.) and missile/rocket structural components when an NDI Program Plan is required by contract. NDI Programs are essential to ensuring NDI processes are implemented to support the lifecycle design requirements of the system and its components. NDI Programs are applicable to all phases of the system life cycle, including acquisition, modification, and sustainment. This standard may also be applicable to mechanical equipment, subsystems, and propulsion systems, but the requirements defined by the NDI Program Plan should be tailored by the contracting agency for such use.
Standard

Inspection Material, Penetrant
2020-07-14
CURRENT
AMS2644H
This specification establishes the classification, technical requirements, tests, and test procedures for the qualification, approval, and quality verification of all materials used in the liquid penetrant methods of inspection with the exception of those excluded in the application section.
Standard

Eddy Current Inspection of Circular Holes in Nonferrous Metallic Aircraft Engine Hardware
2019-10-14
CURRENT
AS4787A
This SAE Aerospace Standard (AS) establishes minimum requirements for eddy current inspection of circular holes in nonferrous, metallic, low conductivity (less than 5% IACS) aircraft engine hardware with fasteners removed. The inspection is intended to be performed at maintenance and overhaul facilities on engine run hardware.
Standard

Exposure Levels of UV Radiation in Nondestructive Inspection Processes
2019-08-05
CURRENT
AIR4964
Long wave ultraviolet or UV-A radiation (between 320 to 400 nm) is used for fluorescent inspections in magnetic particle and liquid penetrant examinations. The UV-A radiation is obtained from either fluorescent or high intensity discharge lamps that are stationary or portable. The commercially available UV-A lamps possess a large variation in intensity output that can cause a legitimate concern for possible health hazard. This draft reviews the nature of UV-A radiation emitted by these lights, blacklight equipment, acceptable UV dosage limits adopted by the American Conference of Governmental Industrial Hygienists (ACGIH) and the European Standards Committee for Nondestructive Testing, and recommendation of proper practices when working with UV-A radiation.
Standard

Ultrasonic Inspection Thin Wall Metal Tubing
2019-04-24
HISTORICAL
AMS2634B
This specification covers procedures for ultrasonic inspection of thin wall metal tubing of titanium, titanium alloy, and corrosion and heat resistant steels and alloys having nominal OD over 0.1875 inch (4.762 mm) with OD to wall thickness ratio of 8 or greater and wall thickness variation not exceeding ±10% of nominal.
Standard

Inspection Material, Penetrant
2019-04-08
HISTORICAL
AMS2644G
This specification establishes the classification, technical requirements, tests, and test procedures for the qualification, approval, and quality verification of all materials used in the liquid penetrant methods of inspection with the exception of those excluded in the application section.
<< First< Previous1234Next >Last >>
X