Search Results

This specification covers two types of polyurethane coatings.

This specification covers two types of polyurethane coatings.

This specification establishes requirements for three types of corrosion preventative coatings for protection of aircraft integral fuel tanks.

This specification establishes requirements for three types of corrosion preventative coatings for protection of aircraft integral fuel tanks.

This specification covers three types of corrosion preventative coatings for protection of aircraft integral fuel tanks.

This specification covers three types of corrosion preventative coatings for protection of aircraft integral fuel tanks.

This specification covers interior aircraft cabin coatings, which when tested under specified conditions exhibit low heat release and smoke release properties.

This specification covers interior aircraft cabin coatings, which when tested under specified conditions exhibit low heat release and smoke release properties.

This specification covers a barrier coating in the form of a ready-to-be applied liquid with a consistency suitable for brush, spray, or dip application to exterior surfaces of aircraft. Primarily as a temporary protective coating for painted and unpainted exterior surfaces of aircraft to ease soil removal from difficult-to-clean areas and to increase paint durability.

This specification covers a two-component, polytetrafluoroethylene-filled polyurethane coating material supplied in kit form.

This specification covers a two-component, polytetrafluoroethylene-filled polyurethane coating material supplied in kit form.

This specification covers the requirements for two classes and two types of rain erosion resistant coatings. This specification has been prepared as a direct replacement for the Military Specification MIL-C-83231A Notice 1. These products have been used for protecting glass fabric reinforced plastic laminates and other plastic parts used for exterior surfaces of aircraft and missiles, but usage is not limited to such applications.

This specification covers the requirements for two classes and two types of rain erosion resistant coatings.

This specification covers the requirements for two classes and two types of rain erosion resistant coatings. This specification has been prepared as a direct replacement for the Military Specification MIL-C-83231A Notice 1.

This standard defines a color index system used by, but not limited to, Government activities in a format suitable for color identification, color selection, color matching, and quality control inspection. It also describes the designation and use of color media that is available to conduct these activities. Use of the color index referenced in this standard is intended to promote standardization and consistency in the color of items produced for Government use. Color media is described as follows: a Color Chip Representation, Fan Deck: Suitable for color identification and selection. b Color Chip Representation, Color Book: Suitable for color identification and selection. c Precise Color Matching, Individual Color Chips: Suitable for color matching and quality control inspection purposes. d Precise Color Matching, Set of Color Chips: Suitable for color matching and quality control inspection purposes.

This standard presents the colors used by Government Activities in a format suitable for color selection, color matching and for quality control inspection. This document describes the designation and use of the color chips of this standard. Formats for color chip representation and precise color matching formats are as described below: a Color Chip Representation, Fan Deck: Suitable for color identification and selection. b Color Chip Representation, Color Book: Suitable for color identification, comparison and selection. c Precise Color Matching, Individual Color Chips: A 3 × 5 inch color chip supplied in a 3 × 5 inch protective envelope, suitable for color matching and quality control inspection purposes. d Precise Color Matching, Sets of Color Chips: A set containing one 3 × 5 inch color chip in its protective envelope for each Fed-Std-595 color, suitable for color matching and quality control inspection purposes.

This SAE Standard defines the general requirements and provides a system for the control of quality for conformal coatings suitable for application to printed circuit assemblies.