Search Results

The advent of high-performance, compact, and lightweight engines in recent years brings forth a tendency to increase the load for engine bearings and demands on producing even higher levels of durability and reliability in bearing products against fatigue, seizure, wear, and corrosion. Based on the perspective of extending the bearing life, the authors have studied the problems that are encountered with the current three layer copper-lead alloy bearings after their overlay has worn out. Then, we studied the issues of lowered seizure resistance that results from the exposure of the nickel barrier, and of deficient corrosion resistance that results from the exposure of the bearing alloy. In order to improve upon these areas, we focused on diffusion phenomenon of overlay elements without the nickel barrier and also studied the feasibility of creating engine bearings whose alloy composition has been partially modified.

We studied the use of SiC porous material for diesel particulate filters. Crystallities of SiC grow into hexagonal plates during sintering,but their sizes have not been controllable yet. We developed a production process that makes the average pore diameter as desired in limiting the pore size distribution to a narrow range. Diesel particulate filters made of SiC greatly reduce pressure loss even when a large quantity of particulates accumulates as compared with conventional wall-flow type filter of cordierite of the same size. This enables particulate filter to be made smaller. The good thermal conductivity of SiC allows fast regeneration without a temperature spike, but its large coefficient of thermal expansion causes heat cracks during rig tests and engine bench tests. The rig tests showed that the heat cracking problem can be solved if the length and diameter are below a certain threshold for each.

The characteristics of a new diesel particulate filter material made of SiC were studied through engine tests in varying material properties, such as average pore diameter, and wall thickness. Compared to a conventional cordierite filter of the same size, particulate trapping efficiency is almost the same, and the pressure loss and the deterioration of fuel consumption can be reduced to about half with the optimum material properties. If the same pressure loss is allowed, the filter size can be reduced by 30%. Its good thermal conductivity prevents local temperature increases, which doubles the permissible amount of trapped particulates. As heat crack problems occurred in integral-type filters due to the high thermal expansion of SiC, a split-type filter having 49 filter segments with a square section was developed.

The influence of tires on straight-running motorcycle weave oscillation has been studied both experimentally and theoretically. Three sets of front and rear tires were used. The weave oscillation was excited by “Nitrogen gas-jet disturbance system” fitted to the instrumented test vehicle. It was shown that the measured damping ratios of yaw rate were in good agreement with the calculations by the mathematical model in which several tire characteristics were considered. The contribution of each tire coefficient to the damping ratio of the weave mode was also examined by parametric studies.