Search Results

The technology for a new, high-strength piston material has been developed by using high pressure die casting (HPDC) method, which had a rapid rate of solidification. This method allowed the amount of Ni added to be increased to 5.5 mass%, raising the fatigue strength of the new material at temperatures of 523 K or higher by a factor of 1.5 over that of a conventional material made by gravity die casting (GDC). In addition, application of vacuum to the die cavity and using additional pressure enabled quality exceeding that of conventional GDC pistons. Pistons made from the newly developed material decreased engine friction by 4.4% and increased fuel efficiency by 2.2% in engine bench testing.

Meeting future exhaust emission and fuel consumption standards for passenger cars will require refinements in how the combustion process is carried out in spark ignition engines. A direct injection system reduces fuel consumption under road load cruising conditions, and stratified charge of the air-fuel mixture is particularly effective for lean combustion. This paper describes an approach to improve combustion stability for direct fuel injection gasoline engines. Effects of spray characteristics (spray pattern and diameter) and air flow motion on the combustion stability were investigated. Spray patterns were observed by the laser sheet scattering method and 3-dimensional laser doppler velocimetry. Mixture behavior in the combustion chamber was observed by the laser-induced fluorescence method using an excimer laser and single cylinder optical engine. It was found that the spray pattern for a pressurized condition affects the combustion stability and smoke generation.

An automotive powertrain total control system using estimated output shaft torque has been investigated in order to enhance drivability and improve fuel economy. The system provides efficient control for both the engine and transmission which leads to an enhancement in drivability by reducing shocks during gear shifts. This paper describes a new smooth gear shift control method using the total control system. By use of the estimated output shaft torque, it is possible to detect accurately the fluctuation condition and the start time of the inertia phase, which are important factors affecting shock occurrence. Torque feedback, got from estimated torque, was applied to the control of engine output shaft torque during shifts. The optimum hydraulic pressure, also got from estimated torque, was applied to the clutch of the transmission during shifts.