Search Results

Unsteady aerodynamic forces acting on vehicles during a dynamic steering action were investigated by numerical simulation, with a special focus on the vehicles' yaw and lateral motions. Two sedan-type vehicles with slightly different geometries at the front pillar, side skirt, under cover, and around the front wheel were adopted for comparison. In the first report, surface pressure on the body and total pressure behind the front wheel were measured in an on-road experiment. Then the relationships between the vehicles' lateral dynamic motion and unsteady aerodynamic characteristics during cornering motions were discussed. In this second report, the vehicles' meandering motions observed in on-road measurements were modeled numerically, and sinusoidal motions of lateral, yaw, and slip angles were imposed. The responding yaw moment was phase averaged, and its phase shift against the imposed slip angle was measured to assess the aerodynamic damping.

Relationships between vehicle's high speed stability during a steering action and following aerodynamic coefficients have already been reported in the past: coefficients for time-averaged aerodynamic lift, yawing moment, side force and rolling moment. In terms of the relationships, however, we have occasionally experienced different high speed stability during steering input even with identical suspension property and almost the same aerodynamic coefficients. A vehicle during high speed cornering shows complex behavior due to unsteady air flow around the vehicle and unintentional steering input from a driver. So it is supposed that the behavior is too complex to be fully described only with those aerodynamic coefficients. Through on-road test [1] and CFD analysis [2,3,4], we have studied unsteady aerodynamic characteristics around a vehicle for pitching motion during straight-line high speed driving.

Aerodynamic noise generated in production vehicle has been evaluated using experiment and numerical simulation. Finite difference method (FDM) and finite element method (FEM) are applied to analyze the flow field, and Lighthill's analogy is employed to conduct acoustic analysis. The flow fields around front-pillar obtained by numerical simulations agree with those by experiment for two cases with different front-pillar shape. Moreover, the distribution of acoustic source predicted by FEM is consistent with that obtained by experiment. Present study ascertained the feasibility and applicability of FEM with SGS model towards prediction of aerodynamic noise generated in production vehicle.

Recently, computational fluid dynamics (CFD) has made great progress. This paper reviews published papers on aerodynamic noise simulated by CFD and studies to what level CFD can predict aerodynamic noise for basic models and for applied models of automobiles. Based on noise generation mechanisms, aerodynamic noise is basically classified into two types, that is, noise induced by two-dimensional flow and by three-dimensional flow. As typical examples of noise generated by two-dimensional flow, wind throb at opened sliding roof, edge tone at the end of liftgate and aeolian tone generated by a cylindrical antenna are simulated by several computational schemes. As typical examples of three-dimensional flow, noise generated by A-pillar longitudinal vortex and noise from a side view mirror are computed by using a wing model and a actual vehicle, respectively.