Search Results

In recent years, small diesel engines for industrial use are required to achieve still higher power output per engine size (high power density) and to have the performance to comply with stringent exhaust emissions standards as well. To meet these social demands and market requirements, there are various engineering tasks yet to accomplish. In this paper, two important technical issues have been focused, those are, combustion system improvement to enable lower exhaust emissions and higher power output than conventional models and new cooling system as a solution for increased heat load issue accompanying the progress of high power density. Firstly, for combustion system improvement, the swirl adjustment technique has been developed that will optimize the swirl ratio for each engine application with different load and speed condition.

The simulation techniques play important role on contemporary engine design. In this study, computer fluid dynamics approach (CFD) was focused to design the intake and combustion system of the direct injection diesel engine for versatile use. A practicality was stressed as much as an accuracy to correspond to designer and researcher's requirements, such as close relationship to the engine performance and short period of computation. The correlation of the trapping efficiency and the swirl ratio was mainly focused. A steady flow rig tests and engine operation data were combined to improve their quality mutually.

Because of recent strong demands for environmental protection, all nonroad engines for agricultural and construction equipment should be conformed to the exhaust emission regulations in Japan, the United States and Europe. Some regulations include transient smoke standard at free acceleration in addition to exhaust emissions at steady state condition such as nitrogen oxides (NOx), hydrocarbon (HC) and particulate matter (PM). Therefore, especially a turbo charged diesel engine needs a countermeasure to reduce the smoke level at free acceleration. This study confirms a mechanism of the smoke discharge at free acceleration and realizes that the injection pattern of the PFR injection pump with timer function reduces the smoke level at free acceleration. As a result, we could develop the engine complied with the transient smoke standard without boost compensater, with which it is very difficult for small engines to make a fine adjustment of proper fuel delivery.

A set of experiments has been performed on a motored four stroke engine measuring the gas phase thermal boundary layer profile adjacent to the cylinder head using speckle interferometry. Speckle interferometry is an optical technique which allows full field, line of sight averaged optical phase shift measurements. These optical phase shift measurements may be interpreted as local temperature values for planar or axisymmetric geometries with ideal gases. For this set of experiments, a small (20 mm diameter) portion of the cylinder head was raised 2 mm above the rest of the surface and used as a test surface. The experiments were performed at two engine speeds, 300 and 750 RPM and at low and high intake swirl levels. Interferograms were obtained at 10 crank angle degree intervals from 70° before top dead center of compression to 60° after top dead center of compression.