Search Results

In order to evaluate the toughness of automotive ECU's to electrostatic discharge, a conventional method where electrostatic discharge pulse is applied to connector parts on a printed circuit board is commonly used. But quantitative re-designing principles to improve the static electricity tolerance have not been made clear that completely utilizes the test data shown below till now, because propagation mechanism of static electricity on a circuit board is not clear. This paper describes the ESD current measurement technique which detects the near magnetic field generated by ESD currents. We developed to measure the ESD currents using the new loop antenna on a circuit board. The ESD current, was generated with the static electricity applied to a model circuit pattern in conformity with IEC and ISO standard and measured using the antenna. Also it was able to visualize how static electricity energy would propagate through the circuit board.

Sensors which can detect minimal acceleration such as ± 9.8 m/sec2 in longitudinal and lateral direction of a vehicle, for DC to 20 Hz range, are required to control ABS (anti-lock braking system) or suspension system. To fulfill these requirements, we have developed a one-dimensional acceleration sensor, using magnetic fluid, to control the vehicle. In 1992, we submitted a paper on this sensor at the SAE International Congress and Exposition. Based on this one-dimensional acceleration sensor, we have developed an acceleration sensor which can detect two dimensional acceleration using a single inertia mass. This sensor is compact and can detect minimal acceleration with high accuracy. Spring and damping functions were obtained via the adoption of magnetic fluid, as in the case of the former one-dimensional acceleration sensor. This sensor can sustain mechanical shocks.