Search Results

Multiple site damage (MSD) on aging aircraft accumulates from fatigue loading over a period of time. For ductile materials such as 2024-T3 aluminum, MSD may lower the strength below that which is predicted by conventional fracture mechanics. An analytical model referred to as the linkup (or plastic zone touch) model has previously been used to describe this phenomenon. However, the linkup model has been shown to produce inaccurate results for many configurations. This paper describes several modifications of the linkup model developed from empirical analyses. These modified linkup models have been shown to produce accurate results over a wide range of configurations for both unstiffened and stiffened flat 2024-T3 panels with MSD at open holes. These modified models are easy to use and give quick and accurate results over a large range of parameters.

An experimental investigation on the effects of Gurney flaps on a reflection plane model was conducted. Two sizes of Gurney flaps were tested on a series of configurations which included a tapered wing (with a NLF-0215 airfoil section), a fuselage, a nacelle, and their permutations. The tests were conducted at a Reynolds number of 1.0 million based on mean chord. Results indicated that lift and drag were increased upon using the Gurney flaps; lift to drag and lift squared to drag ratios were also increased. In particular, the lift to drag ratio for the complete “airplane” was almost the same with or without a small Gurney flap. Pitching moment became more negative (nose-down) with the Gurney flap, and positive (nose-up) with the addition of the fuselage.

The effect of Gurney flaps on three-dimensional wings was investigated in the 7x10 feet low speed wind tunnel. There have been a number of studies on Gurney flaps in recent years. However, these studies have been limited to two-dimensional airfoils. A comprehensive investigation on the effect of Gurney flaps for a wide range of configurations and test conditions was conducted at Wichita State University. In this part of the investigation, straight and tapered three-dimensional wings with Natural Laminar Flow (NLF) airfoil sections were tested. Gurney flaps spanning 4.5, 3.0, and 1.5 feet were tested on a straight NLF wing of 5 feet span. Compared to the clean wing, the 4.5 feet span 0.017c and 0.033c height Gurney flaps increased the maximum lift coefficient by 17% and 22%, respectively. The increase in maximum lift coefficient was proportionately smaller with the shorter span Gurney flaps.

The effect of Gurney flaps on a NACA 0011 airfoil was investigated. Gurney flaps provide a substantial increase in lift while the penalty in drag is small. With the Gurney flap, the airfoil pressure distribution shows increased suction on the upper surface and higher pressure on the lower surface compared to the clean airfoil. This change in pressure is most profound on the lower surface just in front of the Gurney flap. Since separation occurs on the upper surface upon stall, this higher pressure condition on the lower surface continues into the post-stall regime. Thus, the NACA 0011 airfoil with Gurney flaps generates lift coefficients greater than one even under post-stall conditions.