Search Results

Ford Motor Company has developed a new 3.5L V6 engine. The engine, called the Duratec35, represents a new architecture for Ford Motor Co. that will eventually power one in five Ford vehicles. The goals of the engine design were high output, fuel efficient, low emissions, and excellent NVH. This paper will describe the NVH process for the development of the engine, the NVH features included in the design, and the final results relative to the benchmarks.

Piston slap is a problem that plagues many engines. One of the most difficult aspects of designing to eliminate piston slap is that slight differences in operating conditions and in part geometries from build to build can create large differences in the magnitude of piston slap. In this paper we will describe a design for robustness CAE approach to eliminating piston slap. This approach considers the variations of the significant control factors in the design, e.g. piston pin offset, piston skirt design, etc. as well as the variation in the noise factors the system is subjected to, e.g. assembly clearance, skirt collapse, peak cylinder pressure, cylinder pressure rise rate, and location of peak cylinder pressure. Using analytical knowledge about how these various factors impact the generation of piston slap, a piston design for low levels of piston slap can be determined that is robust to the various noise factors.

The demands of modern society continue to drive automotive design to greater efficiency and cleaner operation at lower cost. Higher operating temperatures are now typically required to meet these demands, making the use of more robust materials and joining techniques a necessity. This paper describes how the benefits of reduced emissions and greater fuel economy along with quieter operation are achieved by using silicon-molybdenum modified ductile iron exhaust manifolds welded to close-coupled 400 series stainless steel catalyst cans. This weldment is made possible by using a newly-developed stabilized Ni-Fe-Mn-Cr-Cb welding wire called NI-ROD® Filler Metal 44HT. Durability testing of fabricated exhaust components under extreme dynamometer testing has shown that this welding material provides successful higher temperature performance by the ductile iron than that provided by previous weldments of the same iron.

Gas-assist injection molding is a relatively new process. It is an extension of conventional injection molding and allows molders to make larger parts having projected areas or cross sectional geometries not previously possible using existing equipment. However, controlling the injection of the gas has been a concern. The plastics industry is attempting to establish logical techniques to set up and rationalize processing conditions for the method. Although gas injection equipment permits a number of adjustments, an optimum processing window must be established to provide control and repeatability of the process to mold consistent, acceptable parts. This paper describes a strategy and equipment for rationalizing and accurately controlling gas injection processing conditions that are applicable regardless of the type of molding machine or processing license a molder is using.

The gas injection molding process created a great deal of interest when it was first introduced, especially on the part of the automotive plastics industry. The process allows injection molders to make larger parts with increased rigidity at lower clamping pressures. This, in turn, allows parts to be molded that have not previously been able to be created. However, the process has been hampered by problems. First and foremost have been the numerous patent infringement suits and licensing difficulties that have retarded the spread of the technology in the United States. Second, technological problems - such as controlling the seemingly erratic nature of the gas - have also been an issue. As with any new molding technology, the plastics industry is still attempting to establish logical techniques to set up and rationalize processing conditions for the method.