Search Results

Results of Computational Fluid Dynamic (CFD) analyses of different diesel fuel injector nozzle configurations using a commercial CFD code are presented here. The emphasis of this study is on comparing cavitation models available in the commercial code with respect to their mathematical approach. One of the models is a simple single-phase model based on the Barotropic equation of state, while the other model is a two-phase model based on the bubble dynamic considerations. Results are compared for various 3-D diesel injector nozzles using the two cavitation-modeling approaches. Simulation results are observed to substantiate some of the experimentally established facts like; nozzle efficiency improvements by using techniques like rounded orifice inlets and conical orifices. Also, simulation results agree well with the experimental results. Spray characteristics are predicted based on a primary breakup model.

A quantitative and time-resolved technique has been developed to probe the fuel distribution very near the nozzle of a high-pressure diesel injector. This technique uses the absorption of synchrotron x-rays to measure the fuel mass with good time and position resolution. The penetrating power of x-rays allows measurements that are difficult with other techniques, such as quantitative measurements of the mass and penetration measurements of the trailing edge of the spray. Line-of-sight measurements were used to determine the fuel density as a function of time. The high time resolution and quantitative nature of the measurement also permit an accurate measure of the instantaneous mass flow rate through the nozzle.

A quantitative and time-resolved technique has been developed to probe the dense spray structure of direct-injection (DI) gasoline sprays in near-nozzle region. This technique uses the line-of-sight absorption of monochromatic x-rays from a synchrotron source to measure the fuel mass with time resolution better than 1 μs. The small scattering cross-section of fuel at x-rays regime allows direct measurements of spray structure that are difficult with most visible-light optical techniques. Appropriate models were developed to determine the fuel density as a function of time.

Exhaust emissions consisting of oxides of nitrogen (collectively known as NOx) from internal combustion engines present a serious environmental problem. Although the problem exists for both gasoline and diesel engines, the problem is more severe for the diesel engine. NOx formation in an engine depends strongly on flame temperature, and flame temperature is dependent upon the composition of the fuel and the intake air. The concept is to develop and test copolymer modules for Nitrogen Enriched Air (NEA) supply to diesel engines. The objective is to minimize NOx production from diesel engine emissions without a significant loss of fuel efficiency or a significant increase in carbon monoxide and smoke related emissions. In the present study, a module using the latest membrane technology was designed, tested and fabricated. The modules were installed in a diesel engine test stand and tests were run. The NOx level from the test engine using standard air was established.