Search Results

The hydrocarbon-SCR activity of a silver catalyst has been examined using actual exhaust gas from a diesel engine, without any fuel being added to the reactor inlet. This work is a further step in the development of an active lean-NOx catalyst for aftertreatment of exhaust streams that contain an excess of hydrocarbon relative to NOx. The engine tests follow on from laboratory studies, in which the activity was related to the composition and formulation of the catalyst, the concentration and speciation of the hydrocarbon reductants, and the composition and temperature of simulated exhaust gas. In all the tests described here, the exhaust gas has been provided by an engine operating on ultra-low sulphur diesel fuel. NOx-reduction has been measured as a function of engine load, engine speed, in-cylinder fuel injection timing, exhaust gas temperature, and exhaust gas recirculation. Over 60% conversion to N2 has been achieved at exhaust gas temperatures around 290°C.

The health threat from sub-100 nm particulates, emitted in significant numbers from gasoline vehicles, and anticipated changes in legislation to address this, have prompted investigation of techniques capable of trapping and oxidizing particulates from gasoline engines. Numerical studies have indicated that cooling to encourage particle capture by thermophoresis is less effective than use of electrostatic fields. A laboratory wire-cylinder electrostatic trap is under development, showing promising initial results. As an alternative trapping technique, the effectiveness of a cordierite wall-flow filter has been demonstrated, in simulation experiments and on a GDI-engined vehicle. Catalysts have been identified for particulate oxidation at typical exhaust temperatures, using water vapour and carbon dioxide as the oxygen source and retaining activity after short-term high-temperature aging.

The low exhaust gas temperatures experienced on light duty Diesel vehicles present a very challenging environment for the successful operation of catalytic aftertreatment. To meet the future more severe legislation, Diesel engines are being developed with greater combustion efficiencies and advanced fueling control. These engine developments may produce lower particulate matter (PM) and nitrogen oxides (NOx) emissions, but increased hydrocarbon (HC) and carbon monoxide (CO) emissions may occur. As a result of these engine changes exhaust gas temperatures may reduce still further. These factors demand catalysts with high oxidation activity at low temperatures. This paper reviews oxidation catalyst technology developed for light duty Diesel vehicles and the factors affecting their performance. Results obtained on synthetic gas rigs, bench engines and vehicles are presented. A discussion oh the effect of the level of sulfur (S) present in Diesel fuel on aftertreatment is given.