Search Results

This paper describes an experimental investigation into the surface heat transfer coefficient of finned metal cylinders in a free air stream. Ten cylinders were tested with four different fin pitches and five different fin lengths. The cylinders and their fins were designed to be representative of those found on a motorcycle engine with an external cylinder diameter of 100mm and fin lengths of 10 to 50mm. The fins of each cylinder were gravity die cast in aluminium alloy. Each cylinder was electrically heated and mounted in a wind tunnel which subjected it to a range of air speeds between 2 and 20 m/s. The surface heat transfer coefficient, h, was found primarily to be a function of the air speed and the fin separation, with fin length having a lesser effect. In addition to the determination of an overall heat transfer coefficient, the distribution of cooling around the circumference of each cylinder was also studied.

This paper describes an experimental investigation into the surface heat transfer coefficient of finned metal cylinders in a free air stream. Eight cast aluminium alloy cylinders were tested with four different fin pitches and five different fin lengths. The cylinders and their fins were designed to be representative of those found on a motorcycle engine. Each electrically heated cylinder was mounted in a wind tunnel and subjected to a range of air speeds between 2 and 20 m/s. The surface heat transfer coefficient, h, was found primarily to be a function of the air speed and the fin separation, with fin length having a lesser effect. The coefficient increases with airspeed and as the fins are separated or shortened. It was also noted that a limiting value of coefficient exists, influenced only by airspeed. Above the limiting value the surface heat transfer could not be increased by further separation of the fins or reduction in their length.

Loop heat pipes (LHP) combine the classical heat pipe operation principle with a loop configuration, i.e. evaporator and condenser are located at separate places as dictated by thermal and configurational reasons and are connected lines for fluid and vapor transport. Experimental investigations of such LHP revealed certain temperature oscillations under certain conditions. This paper presents the results of analyses of such temperature fluctuations and offers possible explanations for initiation and termination of such behavior. Two types of temperature fluctuations have also been confirmed experimentally by testing different kinds of LHP.