Axial Turbine Turbocharger for Charging a Lean-Burn Gasoline Engine 2022-01-0377

A single-stage turbocharger turbine is developed with the objective of enabling a gasoline spark-ignition engine to operate under lean-burn conditions with an air-to-fuel ratio of λ=2 in the range of the Worldwide Harmonized Light-Duty Vehicles Test Cycle. For this purpose, extensive 1-D engine simulations are performed using a combination of a simple compressor and simple turbine model as well as a combination of the stock compressor and a simple turbine model. The results show that an isentropic turbine efficiency of more than 70% over a wide operating range is required for the desired engine operation - especially with regard to the low-end-torque. Based on the crank-angle-resolved engine simulation data, turbine requirements are determined. Their evaluation shows that an axial turbine is a reasonable alternative to conventional radial turbines for this application. Next, a preliminary axial turbine is designed using 1-D/2-D design approaches. Then, the corresponding performance map is calculated by 3-D CFD simulations showing isentropic total-to-static turbine efficiencies of up to 77% over a wide operating range. Ultimately, the derived turbine performance map is implemented into the 1-D engine model and the valve train settings are optimized for this configuration to enhance the lean-burn performance further. The simulation results show a significantly extended λ=2 operating range in comparison to the stock turbine.