Browse Publications Technical Papers 2019-01-0142
2019-04-02

Analysis and Mathematical Modeling of Car-Following Behavior of Automated Vehicles for Safety Evaluation 2019-01-0142

With the emergence of Driving Automation Systems (SAE levels 1-5), the necessity arises for methods of evaluating these systems. However, these systems are much more challenging to evaluate than traditional safety features (SAE level 0). This is because an understanding of the Driving Automation system’s response in all possible scenarios is desired, but prohibitive to comprehensively test. Hence, this paper attempts to evaluate one such system, by modeling its behavior. The model generated parameters not only allow for objective comparison between vehicles, but also provide a more complete understanding of the system. The model can also be used to extrapolate results by simulating other scenarios without the need for conducting more tests.
In this paper, low speed automated driving (also known as Traffic Jam Assist (TJA)) is studied. This study focused on the longitudinal behavior of automated vehicles while following a lead vehicle (LV) in traffic jam scenarios. The automated vehicle behavior is modeled using three car-following models. The models are then used to predict the behavior of the vehicle in a randomized scenario. This also serves as validation of the models.
In this study, three vehicles were used: a 2017 Mercedes E300, a 2017 Tesla Model S 90D, and a 2017 Volvo S90. The vehicles were tested using a typical traffic scenario, where the subject vehicle (SV) follows an LV (a 2015 Lexus LS460L). Two different velocity profiles were used, one for model fit and another for model validation. The acceleration, velocity, and position of both the SV and LV were recorded. The data for each SV were fit to three car-following models: Gazis-Herman-Rothery (GHR) model, and two novel physics-based car-following models; Stationary Time-To-Collision (STTC) model and Spring-Mass-Damper (SMD) model.
The performance of these models was evaluated by assessing their ability to predict the resulting acceleration of the SV when presented with random LV speed data. The car-following model parameters for the vehicles were then used to objectively compare their relative performance and safety. The model parameters were used to compute metrics like the SV’s response delay, system dynamics, steady-state response, time-to-collision (TTC) characteristics, etc.
The results indicate that the new SMD and STTC models are comparable in performance to the GHR model in predicting the SV accelerations. The SMD model, in addition to being accurate, also gives further insight into the safety of the vehicles. Though the STTC model predicted the SV acceleration accurately, the model coefficients could not be used to reliably gain insights into the vehicle following behavior.

SAE MOBILUS

Subscribers can view annotate, and download all of SAE's content. Learn More »

Access SAE MOBILUS »

Members save up to 16% off list price.
Login to see discount.
We also recommend:
TECHNICAL PAPER

Virtual Traffic Simulator for Connected and Automated Vehicles

2019-01-0676

View Details

TECHNICAL PAPER

Optimization of Vehicle Operating Conditions by Using Simulation Modeling Software

2019-01-0099

View Details

TECHNICAL PAPER

The Robustly-Safe Automated Driving System for Enhanced Active Safety

2017-01-1406

View Details

X