Investigations of Piston Ring Pack and Skirt Contributions to Motored Engine Friction 2008-01-1046

An experimental study has been carried out to examine the influence of ring tan load and piston skirt modifications on piston assembly friction under motored engine conditions for initial temperatures of -20, 0 and 30°C and motoring speeds within the range 400 to 2000 rev/min. The study has been carried out using the block, crankshaft and pistons of a 2.4I, 4 cylinder diesel engine with a bore and stroke of 89.9mm and 94.6mm respectively. The pistons examined are typical of current designs for light duty diesels. A range of ring pack and piston skirt modifications have been tested, in each case as part of a complete piston assembly. The first changes produced reductions in fmep of between 5% and 38%. The reduction was due to improved skirt and ring pack designs in equal measure, each giving improvements of up to 20%. From this baseline eliminating the tan load of the piston rings was projected to give a further reduction in fmep of between 10% and 20%. Increasing the piston diametric clearances by close to the difference between minimum and maximum grade clearance gave smaller improvements of between 2% and 10% relative to the baseline, and reducing skirt roughness to perfectly smooth gave a projected reduction of typically 4%, and more at low oil viscosities.