Modelling Factors of Square Tubes in High Speed Bending Situations 2007-01-0887

Accurate finite element crash simulations of side impact depend upon a thorough understanding of dynamic tube bending. There is a need to understand the dynamic bending mode of square sections (equivalent of automotive structural parts) to obtain a greater confidence in CAE. This work varied strain rate and material definitions, such as Cowper-Symonds vs Zerilli-Armstrong, as well as initial velocity and yield strength. The results show that most of the plastic work is done between strains rates of 30 - 300/s and strains up to 0.3. Peak strain rates were marginally above 1000/s with maximum strain greater than 1. When the strain rate definition and material model were modified, it was shown that a higher yield stress produced a higher reaction force. These results would suggest that the strain rate sensitivity needs to be carefully identified for accurate crash simulations.