Search Results

Air quality monitoring of PM10 and associated health studies have focused interest on the size and the number of particles emitted to, and found in, the atmosphere. Automotive sources are one of the important elements in this, and CONCAWE have completed a study of heavy duty diesel particle emissions, complementing their previously reported light duty work. This heavy duty programme, presented here, investigated the nature of particulate emissions from two heavy duty engines (representative of different emissions levels), operating on three marketed fuels, over their respective European legislative heavy duty test cycles. The programme has investigated some of the complexities associated with obtaining credible data (e.g. dilution ratios, system stabilisation time etc.). The number distributions, which were measured over a wide size range (3 to 1000 nm), have been split into two size ranges, representative of nucleation mode and accumulation mode particles.

Certain polycyclic aromatic hydrocarbons (PAH) are carcinogenic and discussion will commence shortly in Europe on the development of an appropriate ambient air quality standard. With this proposed standard in mind, it is important to understand the contribution made by different emission sources to ambient PAH; this paper addresses only the contribution from automotive exhaust emissions. Methods for the sampling and analysis of particulate bound PAH from exhaust emissions, although not standardised, are well established. Vapour phase PAH however, are often neglected and need to be accurately quantified to assess the total contribution made by automotive sources to anthropogenic PAH emissions to the atmosphere. This paper describes the development of a technique applicable to the simultaneous collection and measurement of both vapour phase and particulate bound PAH in exhaust emissions. The final method selection focused on a filter/adsorbent trap sampler.

The influence of fuel density on exhaust emissions from diesel engines has been investigated in a number of studies and these have generally concluded that particulate emissions rise with increasing density This paper reviews recent work in this area, including the European Programme on Emissions, Fuels and Engine Technologies (EPEFE) and reports on a complementary study conducted by CONCAWE, in cooperation with AVL List GmbH The project was carried out with a passenger car equipped with an advanced technology high speed direct injection turbocharged / intercooled diesel engine fitted with a complex engine management system which was referenced to a specific fuel density This production model featured electronic diesel control, closed loop exhaust gas recirculation and an exhaust oxidation catalyst Tests were carried out with two EPEFE fuels which excluded the influence of key fuel properties other than density (828 8 and 855 1 kg/m3) Engine operation was adjusted for changes in fuel density by resetting the electronic programmable, read-only memory to obtain the same energy output from the two test fuels In chassis dynamometer tests over the ECE15 + EUDC test cycle the major impact of fuel density on particulate emissions for advanced engine technology/engine management systems was established A large proportion of the density effect on particulate and NOx emissions was due to physical interaction between fuel density and the electronic engine management system Limited bench engine testing of the basic engine showed that nearly complete compensation of the density effect on smoke (particulate) emissions could be achieved when no advanced technology was applied