Search Results

This paper presents an optical technique called fringe projection to measure three dimensional tire deformation subjected to different loads, percentages of deflection and yaw angles. Unlike the well-known Moire method, the proposed technique uses a single light source and a grating, thus requiring no image superposition. As a result, the measurement is not as sensitive to vibration as the Moire method. The fringe projection also differs from the commonly used optical inspection technique in manufacturing industry via line scanning known as structured light, which cannot be applied to dynamic deformation measurements. The recently developed subpixel resolution was employed to accurately locate the optical fringe centers, which in turn improves the accuracy in 3-D geometry determination. A fiber-optic displacement sensor was also placed close to the tire sidewall in order to measure the deformational change of a selected reference point.

Although radial tires have been used in automobiles, they are still in the stage of testing for a possible future use in aircraft. An important consideration is the tire's average life when subjected to various loading conditions. Along with this consideration, tire deformation is one of the concerns. This paper presents a study of deformation comparison between F16 bias and radial aircraft tires subjected to loading conditions against flat plate and flywheel with different percentages of tire deflection and different yaw angles. Optical fringe projection technique is used to determine the three dimensional tire deformation. Like any other similar optical technique, the deformed surface is measured relative to the selected reference point. Therefore, in order to find the absolute geometry of the deformed tire surface, a close-range fiber optic displacement sensor was installed to accurately detect the point's height change in a direction parallel to the wheel axle.

The main objective of this research was to apply an optical technique called fringe projection to quantifying the aircraft tire deformation and strains. The proposed fringe projection technique, using a single light source and a grating, requires no image superposition. Thus, the measurement is not very sensitive to vibration. Three different types of tires in static and dynamic conditions, subjected to different amounts of tire deflections, were tested. A common practice in three dimensional optical measurement is that a fixed reference plane has to be established, from which a fixed reference point is selected. The main technical difficulty in this research is that a tire subjected to an applied load not only moves and rotates, but deforms as well. Therefore, the selected reference point changes its position in three dimensions all the time.