Search Results

A 3.4 kW, 42 V permanent magnet alternator based high power generation system was built and tested in the Delphi R&D laboratory. It is belt driven system with 3.37: 1 pulley ratio. The size of the alternator is slightly less than the production CS-144 Lundell machine with 1/3 less inertia. For cost reasons, the controller uses a single SCR bridge rectifier. The prototype, which is capable of producing 34A/80A at idle/cruising speed, has been tested in the laboratory yielding 84.5%/70.7% efficiencies. Up to cruising speed, the system shows an improvement in full load efficiencies of 5-6 percentile points over a similar 14 V permanent magnet machine with dual SCR bridge. This efficiency improvement is due to the reduction in the converter losses as the current is reduced to one third of its 14 V values even with the same copper losses in both machines.

An efficient light weight 425 Watts charging system was developed and built to meet the requirements of a 12-cylinder engine for racing application. The new system consists of a permanent magnet (PM) alternator with MAGNEQUENCH (MQ3) magnets and a high frequency switching regulator to regulate the output voltage over the engine speed range of 2,000-12,000 rpm. The system has been tested for 75% overall efficiency as compared to 38% for the present system over most of the speed range. Excellent dynamic response (less than 1 ms) has been measured, which allows the alternator to support pulsed loads, even if the battery is disconnected during operation. The new system weighs 3.73 kg vs 5.4 kg of the existing system.