Search Results

The Australian New Car Assessment Program (ANCAP) last reported on progress at ESV 1998 in Canada. This is an update of results since then. In 1999 ANCAP decided to harmonize its testing and evaluation procedures with EuroNCAP (ENCAP). This was so ANCAP could use the results of ENCAP testing on European vehicles where the vehicle specifications were essentially similar to those of the Australian model, thereby reducing the number and cost of tests required to produce consumer information. Since 1998 there has generally been an improvement in the crash test performance of new passenger vehicles sold in the Australian market. ANCAP has carried out updates of the small, medium and large car groups, and of four-wheel-drive (4WD) vehicles (SUVs). The new designs in the 4WD group particularly have shown a dramatic improvement in occupant safety as measured by crash tests. These include good results for the Honda CRV, Subaru Forester and Toyota Landcruiser.

Australian NCAP (ANCAP) began in 1992 with full frontal 56 km/h barrier tests and added the 40% offset deformable barrier test shortly afterwards. In 1999 ANCAP decided to harmonize its testing and evaluation procedures with EuroNCAP (ENCAP). This was so ANCAP could use the results of ENCAP testing on European vehicles where the vehicle specifications were essentially similar to those of the Australian model, thereby reducing the number and cost of tests required to produce consumer information. The process has involved a joint Memorandum of Understanding, close communication between technical and management staff, auditing of ANCAP test results by ENCAP and has required very careful examination of vehicle specifications in the respective continents. Presentation of the results has been different to ENCAP based on Australian research.

This paper provides a summary of preliminary results of three car-to-car 90-degree lateral impact crash tests with initially restrained Hybrid III and US-SID dummies. These tests comprised part of a collaborative research project between Monash University, Autoliv Australia and the Royal Automobile Club of Victoria. The overall research project objectives were to investigate the nature of non-struck side occupant injuries in automobile side impacts and to develop technical solutions to reduce these injuries. The test program results showed that a sash belt with a pretensioner and good geometry was effective in reducing occupant lateral excursions and lap belt loads. An increase in occupant neck loading was however observed and measured. Lateral torso seat restraints helped to prevent direct contacts between adjacent occupants resulting in a reduced HIC measured for a non-struck side occupant dummy.