Search Results

The new emission regulations in Europe, EU 6 will promulgate more realistic driving conditions with more stringent HC, CO, NOx and particulate emissions. This legislation will also include the WLTP (Worldwide harmonized Light vehicles Test Procedure) cycle for CO2 measurements and a new requirement called “Real-Driving-Emissions” (RDE) as well. The RDE requirement is to ensure modern vehicles comply with the legislation under all conditions of normal driving. More robust aftertreatment solutions are needed to meet these new requirements. This work introduces an improved three-way catalyst (TWC) for gasoline engines for these new regulations. It is tested under static and dynamic conditions and on several engines and vehicles with various drive cycles. It offers better thermal stability combined with lower backpressure than former TWC generations.

Besides the further reduction of the harmful gaseous emissions (HC, CO and NOx) to reach upcoming emission limits, the discussion on lowering the CO₂ emissions is omnipresent. From engine development point of view further optimization of the stoichiometric-operated gasoline engine as well as the introduction of lean-operated engines are the main development trend. The emission control system can support the engine development by dedicated catalyst technologies as presented in this paper. A new family of TWC technologies offers to tune the catalyst system to the engine performance and the back pressure requirement - which helps to reduce CO₂ emissions. In addition these technologies show improved performance in HC, CO, NOx light-off, and in CO and NOx conversions under dynamic conditions - this again can positively impact the CO₂ emissions as less harsh heating strategies for cold start is required.

The oil ash accumulation on modern three way catalyst (TWC) as well as its influence on catalyst deactivation is evaluated as a parameter of oil consumption, kind of oil additive compound and additive concentration. The oil ash accumulation is characterized by XRF and SEM/EDX in axial direction and into the washcoat depth of the catalyst. The deposition patterns of Ca, Mg, P and Zn are discussed. The catalytic activity of the vehicle and engine bench aged catalysts is measured by performing model gas tests and vehicle tests, respectively. The influence of oil ash accumulation on the lifetime emission behavior of the vehicle is discussed.