Search Results

The period between the start of fuel injection into the combustion chamber and the start of combustion it's known as Ignition Delay (ID) or Delay Time. Delay period in the diesel engine exerts a very great influence on both engine design and performance. Functionally, the ID can be divided into two parts: the physical and chemical delay. The physical delay, it is the time between the beginning of injection and the attainment of chemical reaction conditions. During this period, the fuel is atomized, vaporized, mixed with air and raised to self-ignition temperature. Viscosity governs the physical delay of fuel combustion process, for low viscosity fuels, the physical delay tends to be small and vice versa. The chemical delay, during this period reactions start slowly and the accelerate until inflammation or ignitions takes place. Generally, chemical delay is larger than the physical delay.

Regarding fuels research and development, some preliminary studies - low cost and short time - can be conducted before the traditional engine tests - more expensive and time consuming. Therefore, experimental apparatus, such as a rapid compression machine (RCM) and specific methodologies, such as imaging techniques, are very useful in order to simulate engine combustion with simplicity, agility and flexibility, reducing development time and costs. Imaging techniques allow flame front propagation and ignition delay analysis, which are important parameters to understand fuel performance in engines and also to improve fuel modeling in engine simulation softwares. A RCM was adapted to operate in a spark ignition engine mode. It was used to obtain high-speed photos of flame propagation and ignition delay. Contour plots of the flame front profiles were obtained in successive frames to analyze the flame development with gasoline-ethanol blends.

Nowadays, many researches are being carried out to replace the diesel by alternative fuels. Biodiesel and ethanol are strong candidates for this purpose. However, the experimental study of the combustion of biofuels in engines is not an easy task. Due to the large differences between the properties of the new fuels and the conventional diesel, radical changes may be needed in current engines, developed specifically for the fossil fuel. So, the experimental study of ethanol compression ignition (CI) combustion is not simple to be obtained in conventional engines. Therefore, some experimental apparatus, such as a rapid compression machine (RCM), are useful to conduct this kind of study. This paper describes the RCM adaptations made in order to run CI combustion tests using Ethanol-Powered (ED95) and Diesel (S50) for different compression ratios and injection timing.

The development of a four-stroke engine, spark ignition, with direct injection of fuel into the combustion chamber was an important initiative for the global automotive market. The thermodynamic potential of this type of engine and its significant improvement in fuel economy have meant this technology as focus of a large number of research projects, with the objective to understand, develop and improve the system of direct fuel injection. However, to meet new emission limits set by Euro 5 specification, it was necessary to reevaluate the geometry design of the injector, which resulted in the development of a new component with a larger number of holes and with a diameter reduction (multi-holes injector). This change in the project aims to ensure a better spray, optimizing air / fuel ratio and, consequently, a better process of combustion inside the combustion chamber, satisfying the emission limits established by the applicable norms.