Search Results

Fuel cell is one of the promising candidates for low emission and high efficiency power plant for the next generation vehicles. Currently, general discussions are focused on from where and how to supply hydrogen to the fuel cell stack in a vehicle. Two major concepts are presented; (1) storing pure hydrogen on-board and (2) use of hydrocarbon as a fuel in combination with on-board fuel reformer system to extract hydrogen. Although the reformer idea seems to be rather complicated than the pure hydrogen, the fuel reformer system is very much demanded, due to the energy density of liquid fossil fuel and availability of fuel supply infrastructure. In the development of the fuel reformer system, gas composition measurements are required to achieve (1) efficient hydrogen extraction, (2) low carbon monoxide concentration to protect PEM stack, and (3) low emission.

Numerical models of three kinds of mass emission measurement systems, i.e. the constant volume sampler (CVS) system, the mini-diluter system and the direct modal-mass measurement system have been built on PC using a software called Mathematica®. The models are capable of simulating gas compounds concentration in the CVS bags and mass emitted during a test, using the time trend exhaust emission patterns, the exhaust gas flow rate pattern, and initial setting values like dilution ratio. Major error factors in the measurement systems, such as H2O condensation, gas compounds present in ambient air, delay and smoothing of the gas stream, and performance of the analyzers, can also be introduced to the calculation. Using the models, various techniques to optimize the sampling system are quantitatively compared.

The performance of a soft ionization mass spectrometer (MS) has been investigated using nearly one hundred hydrocarbon components and nine inorganic components. Based on a list of typical hydrocarbon emissions from automotive exhaust, synthesized samples have been used to discuss the cross-sensitivity of the target components. The system has been shown to measure hazardous air pollutants (HAPs) such as 1,3-butadiene, benzene and toluene in the vehicle exhaust. As a result, the technique will prove to be very useful in emissions monitoring in the development of low emissions vehicles.