Search Results

Previously we reported (SAE Paper 2005-01-0475) that emissions of toxicologically relevant compounds from an engine operating at low NOx conditions using Fischer-Tropsch fuel (FT100) were lower than those emissions from the engine using an ultra-low sulfur (15 PPM sulfur) diesel fuel (BP15). Those tests were performed at two operating modes: Mode 6 (4.2 bar BMEP, 2300 RPM) and Mode 11 (2.62 bar BMEP, 1500 RPM). We wanted to evaluate the effect on emissions of operating the engine at low power (near idle) in conjunction with the low NOx strategy. Specifically, we report on emissions of total hydrocarbon (HC), carbon monoxide (CO), NOx, particulates (PM), formaldehyde, acetaldehyde, benzene, 1,3-butadiene, gas phase polyaromatic hydrocarbons (PAH's) and particle phase PAH's from a DaimlerChrysler OM611 CIDI engine using a low NOx engine operating strategy at Mode 22 (1.0 bar BMEP and 1500 RPM).

A previous paper reported (SAE Paper 2002-01-2884) that it was possible to decrease mode-weighted NOx emissions compared to the OEM calibration with corresponding increases in particulate matter (PM) emissions. These PM emission increases were partially overcome with the use of oxygenated diesel fuel additives. We wanted to know if compounds of toxicological concern were emitted more or less using oxygenated diesel fuel additives that were used in conjunction with a modified engine operating strategy to lower engine-out NOx emissions. Emissions of toxicologically relevant compounds from fuels containing triproplyene glycol monomethyl ether and dibutyl maleate were the same or lower compared to a low sulfur fuel (15 ppm sulfur) even under engine operating conditions designed to lower engine-out NOx emissions.

From 1995 to 1997, the Coordinating Research Council (CRC) conducted a cold-start driveability program to evaluate the behavior of lower volatility fuels at cold, intermediate, and warm ambient temperatures. The program used 135 vehicles to evaluate 87 hydrocarbon, MTBE blended, and ethanol blended fuels. Evaporative driveability index equations (EDIs) were developed using the test design fuel variables (E158°F, E200°F, E300°F), and three other variable sets: (E158°F, E250°F, E330°F), (T10, T50, T90), and (E70°C, E100°C, E140°C). The models that best fit the data contained oxygenate offsets. Overall, the best indices are the E70°C, E100°C, E140°C equation and the DI equation with offsets.

Two fleets of thirty vehicles each were emissions tested in order to determine the effect of gasoline RVP reduction on tailpipe carbon monoxide (CO) emissions in Las Vegas and Los Angeles under conditions typical of winter CO exceedances in these two cities. The hypothesized emission reduction was confirmed for Las Vegas. However, for Los Angeles, the effect of RVP was questionable. The reason or reasons for this discrepancy between the two cities could not be completely resolved from this study. Detrimental emissions effects of reduced RVP under cold temperatures were found to be small and inconsequential.