Search Results

A Diesel Particulate Filter (DPF) is needed to meet the Particulate Matter (PM) requirements of US EPA 2007 regulations for diesel engines. A catalyzed diesel particulate filter (cDPF or CSF) in combination with a diesel oxidation catalyst (DOC) is effective if the DOC has achieved light-off. However, for some applications, exhaust temperature will be too low to achieve DOC light-off. Therefore a reliable active regeneration means will be required. This paper presents a diesel-fired filter regenerator that works with an uncoated DPF. During regeneration, the thermal regenerator raises the exhaust temperature to 650 °C at the filter face at any engine condition, including idle. The thermal regenerator was tested on a cordierite filter placed on a heavy-duty diesel engine with cooled-EGR (2007 calibrations). THC, CO and NOx emissions, as well as opacity, in the tailpipe were measured at both steady state and transient engine conditions.

A heavy-duty engine testing project involving Cummins Engine Company, Southwest Research Institute (SwRI), and West Virginia University (WVU) has been completed. This project evaluated the transient exhaust gas emissions rate of Cummins N-14 heavy-duty diesel engines converted to natural gas. Three heavy-duty N-14 diesel engines were converted to run on natural gas using a lean burn strategy by SwRI and are in field service in Santa Barbara Air Pollution Control District (SBAPCD). Two of the engines were tested under a steady-state cycle that simulates the U.S. heavy-duty transient cycle. The third engine was tested at the WVU Engine Research Laboratory following the U.S. Federal Test Procedure (FTP). However, at WVU, lean burn combustion strategy was shifted rich of stoichiometric during idling time of the FTP test. This may have caused the engine to produce more total hydrocarbons (THC) and carbon monoxide (CO).