Search Results

Fuel cell vehicle fuel consumption measurement is considerably different from internal combustion engine vehicle fuel consumption measurement. Conventional Carbon Balance Method and Flow Measurement methods for gas consumption within combustion engines are not suitable for fuel cell vehicles. The small quantities of fuel consumed and the characteristics of hydrogen itself impose a challenge for the hydrogen measurement. This paper addresses fuel consumption measurement for fuel cell vehicles using various methods such as mass flow measurement, pressure/temperature/volume method, weigh method as well as other methods. The advantages and disadvantages of these methods are discussed.

Hydrogen Fuel cell vehicles, and techniques for fuel economy measurement and fuel economy calculations are considerably different from those traditionally used fro combustion engine vehicles.. Like gasoline or diesel hybrid vehicles, fuel cell vehicles typically use batteries or other power systems such as super-capacitors for load leveling. Thus, the energy transfer or consumption from these supplemental power sources to the drive train should be compensated for when determining fuel consumption or fuel economy. This paper addresses fuel economy calculations and testing for hybrid hydrogen fuel cell vehicles. The impact of supplemental power systems to a fuel cell vehicle's fuel economy and the various methods to derive actual vehicle fuel economy with supplemental power system usage are discussed.

An Emergency Tire Inflation System (ETIS) designed for use on commercial trucks was evaluated and tested. The ETIS is provided in kit form and designed to be installed by a truck operator to provide emergency air to inflate a low or punctured tire on tractor drive axles. The ETIS will continue to supply air to the tire until the system pressure falls below a safe air pressure level. The system is designed to allow the rig to be driven 500 miles to a tire repair station or to a safe location where tire repair service is available. The installation kit (Figure 1), which can fit under a truck seat, includes all the necessary equipment to install the system on the most common drive axles. The ETIS supplies air to the under-inflated tire through a previously qualified1 Rotary Union design. The Rotary Union is attached to the axle flange of the drive axle by a threaded adapter and two adjustable links that allow the Rotary Union to be placed at the center of rotation of the axle.

An Automatic Tire Inflation System (ATIS), specifically designed for use on commercial long haul trailers underwent complete testing and evaluation in 1993/1994.1 Testing and evaluation included a field test of a prototype system and a controlled laboratory evaluation of the Rotary Union which is the only component subject to wear. The testing of the prototype system indicated that design improvements were necessary before the system could be installed in fleet operations. The design improvements were completed and field installation of production ATIS began. The design improvements were intended to improve overall system durability, decrease installation time, to have less effect on the axle structure than the original design, implement the use of SAE or DOT Approved pressure components and increase overall dependability of the system. ATIS systems have now been developed and tested for most domestic trailer axle configurations.