Search Results

The objectives of this study are to generate validation data for human models intended for simulation of occupant kinematics in a pre-crash phase, and to evaluate the effect of an integrated safety system on driver kinematics and muscle responses. Eleven male and nine female volunteers, driving a passenger car on ordinary roads, performed maximum voluntary braking; they were also subjected to autonomous braking events with both standard and reversible pre-tensioned restraints. Kinematic data was acquired through film analysis, and surface electromyography (EMG) was recorded bilaterally for muscles in the neck, the upper extremities, and lumbar region. Maximum voluntary contractions (MVCs) were carried out in a driving posture for normalization of the EMG. Seat belt positions, interaction forces, and seat indentions were measured. During normal driving, all muscle activity was below 5% of MVC for females and 9% for males.

Thoracic injuries are one of the main causes of fatalities and severe injuries in car crashes. The tools available today for studying these injuries are not up to par with the latest implementation of restraint systems and airbags. THORAX-FP7 is a collaborative medium scale project under the Seventh Framework. It focuses on the reduction and prevention of thoracic injuries through an improved understanding of the thoracic injury mechanisms and the implementation of this understanding in an updated design for the thorax-shoulder complex of the THOR dummy. The updated dummy should enable the design and evaluation of advanced restraint systems for a wide variety (gender, age and size) of car occupants.

Several investigators have noted limitations of the most commonly used dummy in rear impact testing, the Hybrid III. A dummy for rear impact testing, the BioRID I, has previously been presented. It was a step towards an effective tool for seat performance testing, but it was concluded that its neck extension and T1 upward motion were too small and that its user- friendliness could be improved. A new BioRID prototype has been developed. It has new neck muscle substitutes with damping and elastic elements that are independent of each other and fitted inside the torso. The new neck muscle substitutes extend to T3 and thus also load the upper thoracic spine. The new dummy has a softer thoracic spine and a torso made of softer rubber than was used for the original dummy. The BioRID prototype''s performance was compared to that of volunteers, the BioRID I and Hybrid III in rear impacts at ΔV=7 km/h.

The most important tool to date for testing seat-systems in rear impacts is a crash test dummy. However, investigators have noted limitations of the most commonly used dummy, the Hybrid III. Although the BioRID I is a step closer to a biofidelic crash test dummy it is not user-friendly and the straightening of the thoracic spine kyphosis is smaller than that of humans. The objective of this study is to compare the performance of the latest prototype of the BioRID, the P3, with those of volunteers. The BioRID P3 has new neck muscle substitutes, a softer thoracic spine and a softer rubber torso than does the BioRID I. The BioRID P3 was validated against volunteer test data in both a rigid and a standard seat without head restraints. The dummy kinematic performance, pressure distribution between subject and seatback, spine curvature, neck loads and accelerations were compared to those of seven volunteers and a Hybrid III fitted with a standard neck.