Search Results

A cold-start partial oxidation (POX) system was integrated with a modern flexible fuel engine to assess its impact on cold-start performance and emissions. The POX reactor, a small combustion device operating fuel rich, converts liquid fuel into gaseous fuel species (reformate). The reformate from the reactor, when mixed with combustion air, replaces or supplements the standard fuel consumed during an engine start. This prototype integrated cold-start system has successfully reduced emissions from a cold-start on fuel grade ethanol (E95) at 5°C. The integrated POX system reduced the time-averaged hydrocarbon (HC) and carbon monoxide (CO) emissions by 80 and 40 percent, respectively. Starts on E95 reformate were achieved in less than 10 seconds at temperatures as low as -20°C.

A research program designed to measure the contribution from fuel absorption in the thin layer of oil, lubricating the cylinder liner, to the total and speciated HC emissions from a spark ignition engine has been performed. The logic of the experiment design was to test the oil layer mechanism via variations in the oil layer thickness (through the lubricant formulations), solubility of the fuel components in the lubricants, and variations in the crankcase gas phase HC concentration (through crankcase purging). A set of preliminary experiments were carried out to determine the solubility and diffusivity of the fuel components in the individual lubricants. Engine tests showed similar HC emissions among the tested lubricants. No consistent increase was observed with oil viscosity (oil film thickness), contrary to what would be expected if fuel-oil absorption was contributing significantly to engine-out HC. Similarly, no effect of crankcase purging could be observed.

The effect of lubricant composition on vehicle exhaust emissions has been investigated. Emissions from two vehicles were measured when lubricated with four different crankcase lubricants. All emissions tests were performed with California Phase II gasoline over the FTP-75 cycle. The lubricants tested were a conventional mineral oil based lubricant, poly-alpha olefin (PAO) based lubricant, hydrocracked based lubricant and a Volvo first fill lubricant. The first three lubricants were designed to have similar high temperature viscosities whilst using the same additive package. This meant that there were some small differences in the low temperature viscosities. This resulted in the two mineral oil based lubricants being 10W-30 grades and the PAO and hydrocracked based lubricants being 5W-30 grades. The two test vehicles used were both Volvo 850 vehicles, however one was a European specification vehicle and the other a Californian TLEV.

The angular momentum of a tumble vortex occurring inside a 4-valve spark ignition engine was measured by particle tracking velocimetry, PTV. A cylindrical glass liner was designed for a single cylinder motored engine. Light-scattering particles and a laser light sheet, directed through the axis of the cylinder, were used to observe the simultaneous flow field. Three different intake port designs were used in this study. The in-cylinder tumbling motions were measured and the tumble ratios were calculated. The intake configurations were also visualized and measured with PTV in a steady flow rig, at a fixed valve lift. In addition, the results were compared with measurements from a conventional steady flow rig which measures the angular momentum flux with a torque-meter, and with laser doppler measurements, LDV, in a motored engine. All four techniques indicated clearly the qualitative difference between the ability of the intake ports to produce an in-cylinder tumbling motion.