Search Results

Two sets of comparisons were made in an attempt to provide a mechanism for understanding the behavior of transient sprays. First, detailed measurements of drop size and velocity in a transient spray were compared to established stability criteria for different droplet breakup mechanisms, specifically criteria for bag breakup and boundary layer stripping. Then, probability-density-functions were determined from the experimental data and compared, where appropriate, to different computed distributions (such as the Chi-square or log-hyperbolic distributions). Comparison with the stability criteria indicates that the a majority of droplets in the spray are susceptible to both breakup mechanisms near the injector tip. However, downstream, the spray appears to stabilize and any redistribution of droplet size must apparently be a result of collisions. The experimentally-determined PDF's for size and velocity are functions of both position and time in the spray.

Simultaneous droplet sizes and velocities were obtained for a transient diesel fuel spray in a quiescent chamber at atmospheric temperature and pressure. Instantaneous injection pressure, needle lift, and rate of injection were also measured, allowing calculation of the instantaneous nozzle discharge coefficient. Short-exposure still photographs were obtained at various chamber pressure and densities to further investigate this spray. Correlations between droplet size and velocity were determined at each crank angle to observe the detailed nature of the transient events occurring in this transient diesel fuel spray. As expected, peak mean and rms velocities are observed in the center of the spray. Measured average velocities are consistent with a calculated value, using the discharge coefficient for the nozzle and the known rate of fuel injection.

This paper reports on the investigation of injection pressure upon the droplet behavior in transient diesel sprays. Phase/Doppler results for a Diesel spray with a maximum fuel injection line pressure of 105 MPa are compared with previously acquired droplet size and velocity measurements for a Diesel spray with an injection pressure of 21 MPa. All measurements reported here were made in atmospheric conditions at a position near the nozzle. It is shown in these results that the droplet velocity and size profiles do maintain similarity despite the substantial change in injection pressure. Specific characteristics, for example, the appearance of subtle waves in the time-dependent spray data, are present in both data sets. Comparison of the measured droplet velocities and diameters with Weber number based stability criteria shows that increased injection pressure produces a higher percentage of droplets that are likely to breakup.