Search Results

The objective of this paper is to present the results of an investigation of elastic distortions of split piston rings that are used in lubricated and non-lubricated air brake compressors. Concepts of advanced stress analysis and Finite Element Analysis (FEA) have been employed in this study. The analysis of elastic distortions (twist) of piston rings due to the installation stresses has been quite poorly documented in the technical literature. As a result, unjustifiable engineering assumptions are some time made which result in misleading design solutions. This paper demonstrates analytically and with the support of FEA the mechanical/geometrical parameters of a split ring which affect the twist of the ring during the installation in the cylinder bore, and the calculated magnitude of this twist along the ring circumference.

Mobility method is used to analyze the steady-state performance of crankshaft and connecting rod bearings which are subjected to loads whose magnitude and direction both vary in time. The steady-state characteristics include journal center orbit, minimum film thickness, maximum film pressure, effective temperature, flow through the bearing, etc. To extract the stiffness and damping coefficients over the load cycle, linear analysis method based on a short-bearing approximation is employed. In addition, the oil flow through the main and connecting rod bearings is investigated. Sufficient lubrication conditions for these bearings are discussed. This combined analysis is supported by numerical simulations. The case studies are based on AlliedSignal's two-cylinder truck air brake compressor, TU-FLO 550, which illustrate the entire approach.