Refine Your Search

Search Results

Viewing 1 to 2 of 2
Technical Paper

Emissions Characteristics of Soy Methyl Ester Fuels in an IDI Compression Ignition Engine

1995-02-01
950400
As part of an ongoing program to control the emissions of diesel-powered equipment used in underground mines, the U. S. Bureau of Mines evaluated exhaust emissions from a compression ignition engine using oxygenated diesel fuels and a diesel oxidation catalyst (DOC). The fuels include neat (100%) soy methyl ester (SME), and a blend of 30% SME (by volume) with 70% petroleum diesel fuel. A Caterpillar 3304 PCNA engine was tested for approximately 50 hours on each fuel. Compared with commercial low-sulfur diesel fuel (D2), neat SME increased volatile organic diesel particulate matter (DPM) but greatly decreased non-volatile DPM, for a net decrease in total DPM. The DOC further reduced volatile and total DPM NOx emissions were slightly reduced for the case of neat SME, but otherwise were not significantly affected. Peak brake power decreased 9% and brake specific fuel consumption increased 13 to 14% for the neat methyl soyate because of its lower energy content compared with D2.
Technical Paper

Operating Techniques and Maintenance Practices for the Lockheed SST

1966-02-01
660295
The operational and maintenance characteristics of a commercial double delta supersonic transport are compared with those of contemporary subsonic vehicles. It is shown that the large delta wing in combination with the high thrust engines provides exceptional safety margins for take-off and landing conditions. The pilot's viewpoint is given upon low speed handling and controllability in emergency situations. Comments on maintenance considerations peculiar to such an aircraft are made and the general design philosophy is reviewed at this stage of the U. S. Supersonic Transport Program.
X