Search Results

Mixing characteristics of a Direct-Injection engine with liquefied petroleum gas were numerically investigated using a 3D unsteady Eularian-Lagrangian two-phase model. Numerical results were validated to the experimental data of heat release rate, pressure and mass flow rate of air. The numerical results and experimental data were in a good agreement. Simulations were conducted with various engine operation conditions to investigate the effects of supercharging on the mixing characteristics of the DI engine with LPG. The results showed that the fuel uniformities and evaporation rates of LPG are higher than them of gasoline. Fuel consumption rates and maximum cylinder temperatures of LPG were also higher than them of gasoline.

GDI (gasoline direct injection) engine can be one of the solutions to increase the fuel efficiency and reduce NOx (nitrogen oxide) emissions. The LFF (liquid fuel film) formation within the engine cylinder due to direct injection is an impediment to both fuel efficiency and environment problems. To achieve the proper operating conditions, liquid fuel film formation and combustion characteristics in the cylinder of GDI engine must be investigated. The numerical simulations for the characteristics of GDI engine including the effect of both fuel injection and spark timing have been carried out to optimize the liquid fuel film phenomenon and combustion characteristics. In this study, 3D unsteady Eularian-Langrangian two-phase model was used to obtain an optimal operating condition of a GDI engine by using S/W STAR-CD (CD-adapco). The κ-ε/RNG model was used as a turbulence model.

The shape of unit cell of catalytic converter has great influence on the conversion efficiency and pressure drop characteristics. Therefore, the properties of design parameters of catalyst monolith were analyzed and the parameters of various cell shapes of catalyst were compared. Also, the numerical study of a three dimensional compressible flow in a Close-coupled Catalyst Converter (CCC) system was performed to investigate the flow characteristics and the flow distribution of exhaust gases. Unsteady flow analysis shows that severe interferences of each pulsating exhaust gas flow as well as geometric factors (junction, mixing pipe, cell shape etc.) influence greatly on the flow uniformity and flow characteristic in substrate. The results can be applied for the catalytic converter design.

Natural gas is considered to be an alternative fuel for passenger cars, truck transportation and stationary engines that can provide both good environmental effect and energy security. However, as the composition of fuel natural gas varies with the location, climate and other factors, such changes in fuel properties affect emission characteristics and performance of CNG (Compressed Natural Gas) engines. The purpose of the present study is to investigate effects of difference in gas composition on engine performance and hydrocarbon emission characteristics. The results show that THC decreases with an increasing WI (Wobber Index) and MCP (Maximum Combustion Potential) of natural gas. The power is shown to be proportional to the total heat value of the actual amount of gas entering the cylinder. There is 20% power variation depending on the composition of gas when the A/F ratio and spark timing are adjusted and fixed for a specific gas.