Search Results

This paper will focus on fuel flow analysis in nozzles, in particular, in the injection hole, a key component of Fuel Injection Equipment(FIE). Optimum controlled flow in the hole improves flow efficiency and atomization. To meet the emission regulations which will be introduced from the end of '90's to the 21st century, Diesel Engines require FIE to produce higher injection pressure which creates better atomization and higher utilization of air. But higher injection pressure results in increased pump driving torque, larger pump size and higher cost. We have studied the improvement in fuel flow characteristics of the nozzle, using an enlarged flow model and the theoretical analysis method. As a result, we have found that the cavitation, which occurs at the inlet of the hole, is affected by the configuration of the sac hole and injection hole. And, furthermore, the cavitation has a direct effect on the contraction and its recovery flow.

The purpose of this study is to make clear the relationship between flow characteristics in the nozzle and injected spray characteristics. In this paper, we discuss the effect of the sac volume in the standard hole type nozzle on fuel flow and spray. The main object of this paper is to analyze fuel flow characteristics in the nozzle by using the enlarged model nozzles. Spray investigations confirmed that reducing the sac volume causes changes in the fuel injection direction at the initial stage of injection and in the spray penetration over consecutive injection. Flow investigations in the injection hole clarified that meandering the flow in the hole causes changes in the fuel injection direction. Flow investigations in the sac chamber clarified that separating the flow from the sac wall causes meandering the flow in the hole. Furthermore, the methods to restrain the flow in the sac chamber from separating from the sac wall were discussed.

This paper reports on research conducted at Nippondenso Co., Ltd. and Meiji University on nozzles for heavy duty diesel engines. It focuses on fuel flow analysis in the nozzle, a key component of Fuel Injection Systems (FIS). The optimum design nozzle improves fuel flow and spray characteristics. A newer and tougher emission regulation from the EPA for heavy duty diesel engines will be inevitable from 1998 onward. The goal of every company is to design new FIS in advance which meet the regulations of the future rather than paying for expensive developing costs after new laws have come into effect. To meet the regulation, requirements for FIS are higher injection pressure and injection rate control which create better fuel spray atomization and higher utilization of air. In particular, the nozzle must ensure that high injection pressure is effectively converted to fuel spray without pressure losses.

The purpose of this paper is to discuss injection rate control of the nozzle for direct injection engines. This paper will focus on fuel flow analysis of the nozzle, a key component of Fuel Injection Systems (FIS). The optimum designed nozzle improves fuel flow efficiency and controls injection rate. To meet emission regulations in 1990's, FIS are required to produce higher injection pressure and injection rate control which creates better fuel spray atomization and higher utilization of air. But the higher injection pressure makes injection rate control difficult. In particular, injection rate control by needle lift traveling control is difficult because fuel flow characteristics in the nozzle change with injection pressure and needle lift. Furthermore, the forced control of needle lift results in poor fuel spray atomization.

The purpose of this paper is to discuss spray control of nozzle for heavy duty diesel engines. This paper will focus on fuel flow analysis of nozzle, key component of FIE (Fuel Injection Equipment). The optimum designed nozzle controls fuel flow and improves flow efficiency. FIE is required to produce higher injection pressure which creates better atomization and higher utilization of air. But the higher injection pressure results in increased pump driving torque, larger pump size and higher cost. To improve the fuel flow characteristic of nozzle, we analyzed it and developed a theoretical analysis method with computer model simulation to the optimum design nozzle. We also confirmed its effect by experiments.