Search Results

A new urea-dosing device with an active-ammonia production function was developed. This function is achieved by an electrically heated bypass passage with a hydrolysis catalyst for urea-to-ammonia conversion. The new device also has the function of mixing ammonia and exhaust gas. It is compact and has low-pressure loss by using the vortex occurring at the back of a static vane. We built a trial device for a small diesel engine and obtained steady state and transient data. The heated-bypass concept can be used in the aftertreatment system of passenger cars. Although active-ammonia production consumes electric power, a predictive calculation of power consumption (based on experimental results) shows that the developed bypass heater can suppress the energy consumption enough not to harm the high-energy efficiency of diesel engines.

The urea-SCR system is one of the most promising aftertreatment systems for future automotive diesel engines. We developed a urea dosing device with twin urea injectors for onboard applications, to enhance the NOx reduction performance at low exhaust temperatures and to lower the electric power consumption of the SCR system. The injectors operate with a single-phase urea solution, without air assist. Of the injectors, one is used to supply urea to a bypass passage routing the exhaust, during low exhaust temperatures. The other injector is located on the wall of the main exhaust duct, directly supplying urea to the exhaust. This direct injection method has a uniform spray distribution problem. A set of impact plates were used to distribute the spray. Impact plates have a high potential for deposition, but use of film boiling was considered. A thermal analysis was conducted and as a result, deposit conditions were theoretically derived. This was confirmed through experiments.

A smart analog integrated circuit (IC) is developed for use in an electronic control unit for an automotive variable power-steering system. This IC accepts a vehicle speed signal as its input, performs signal processings such as frequency to voltage conversion and function generation, and then as its output generates a pulse width modulated (PWM) signal whose duty corresponds precisely to a given piecewise linear function of the vehicle speed. The PWM output is used as a driving signal to a power MOSFET for the actuation and control of a linearly variable solenoid valve to vary the force needed for steering effort in a prescribed relation to the vehicle speed. The IC is fabricated by monolithic bipolar integrated circuit technology and has about 750 device elements in a chip size of 5.7 by 3.1 mm2. It is enveloped in a shrinked dual in-line package with 24 pins.