Search Results

By using a four-stroke gasoline engine equipped with a fully variable valve operation system, combustion performance was investigated from the aspect of a gas exchanging difference at various internal exhaust gas recirculation conditions due to the negative valve overlap variations. The in-cylinder gas temperature throughout the cycle process was analyzed thermodynamically. The experimental data revealed that in-cylinder gas temperature at the end of compression stroke (TAI) dominates the onset of autoignition and ΔT, which is an index that represents the heat capacity of the working gas, dominates the heat release of auto-ignition. This paper intends to evolve the experimental knowledge to an engineering tool, which could predict possibilities and limits of auto-ignition. As a result, a controlling mechanism of auto-ignition is proposed. According to this mechanism, a possible maximum load of auto-ignition operation is estimated and also demonstrated in the engine experiments.

As an index to control the heat release of auto-ignition combustion, our previous paper introduced a concept of ΔT. It was the difference between the adiabatic flame temperature and the initial in-cylinder gas temperature before the heat release, i.e., ΔT physically represents the heat capacity of the in-cylinder gases relative to the calorific value supplied in a cycle. Firing tests of a four-stroke auto-ignition gasoline engine revealed that the heat release process could be successfully controlled when ΔT was maintained at a proper level. This paper evolved the ΔT theory into the every possible gas exchanging state in the four-stroke engines and found out a chain of the low-temperature combustion cycle (LTC), which continuously varied from the spark-ignition (SI) to auto-ignition (AI). By using a hydraulic-electromagnetic fully-free valve actuator system, the LTC was examined in our 650 cm₃ single-cylinder experimental-engine.

Auto-ignition may be considered as the ultimate combustion process for vehicle engines. Regarding combustion control, ignition timing and heat release are the chief concerns. The former is finding a solution, however the latter has, as yet, several approaches. As a means to control the heat release, this paper introduces a universal parameter; ΔT, which is the difference between the adiabatic flame temperature and the initial in-cylinder gas temperature before combustion. Firing tests of a four-stroke auto-ignition gasoline engine revealed that the heat release process could be successfully controlled when ΔT was maintained at a proper level. As a result, the auto-ignition zone was greatly enlarged in the tested engine with a moderate compression ratio.

Local inhomogeneity of mixture concentration affects combustion characteristics in the lean burn system and also in the stratified charge combustion system. To investigate such combustion systems, the effects of inhomogeneous mixtures were examined using a carefully controlled experimental system. In this study, a constant-volume chamber, which can simulate an idealized stratified charge by using a removable partition inside the chamber, was developed. Flow and combustion characteristics were examined by indicated pressure analysis, Schlieren photography, ion probe measurements and local equivalence ratios measurements while varying the combination of initial equivalence ratios on each side of the partition. As a result, combustion characteristics of charge stratified, very lean propane-air mixture were clarified.