Search Results

A simulation model of the Hybrid III lower extremities with the 30 degree dorsiflexion ankle was developed using the CVS/ATB program. The femur and tibia were modeled as a sequence of rigid beams with a hinge and slider at the knee. Special, locked joints were placed in the femur and tibia at the same locations as the load cells in the actual dummy. Constraint forces and moments at these joints can be compared directly to load cell data. The complex geometry of the foot was divided into five segments representing the heel, toe, forefoot, midfoot, and ankle regions. Two foot models were constructed: one barefoot and one with a Lehigh safety shoe. Good agreement was obtained for most parameters when single-leg pendulum tests, and full-body sled tests, were simulated using the new model.

Experimental testing was performed to provide input data for a new, multi-body computer model of the Hybrid III lower extremity, with the 30 degree dorsiflexion ankle. The leg was disassembled into its components to mass, geometric, and inertial properties for each segment. Stiffness and damping coefficients were measured for the hip, leg, foot, and ankle. Joint rotational and translational properties were measured for the knee and ankle. To characterize interactions of the foot with the footwell, flexion and compression tests of the foot were conducted. The lower extremity was segmented at the joint and load cell locations, to permit rigid body dynamics codes to compute the forces at these locations for comparison to test data and for calculation of injury criteria.