Search Results

Economical and technical aspects justify intelligent suspension systems in commercial vehicles. The tasks of suspensions of vehicles are contradictionary and the prevailing problems cannot be readily solved with conventional suspension systems in a satisfying manner. However, advantages are acquired by the use of adaptive suspension systems. Varying the properties and characteristics of suspension systems in respect to the different loads transported by a commercial vehicle, to vehicle speeds and to dynamic maneuvers, nearly present as good results as closed loop controlled adaptive suspension systems do. For economical reasons fully active suspension systems are only installed in commercial vehicles performing special tasks and services. Partially active suspension systems reduce power consumption and demonstrate satisfactory efficiency.

The consequent means towards improved enhancement of the safety of commercial vehicles will in future times require more and more electronic intelligence, in case a distinct optimization of the systems will not be possible with conventional means. In forefront, endeavours are aimed at the improvements of the functions of the system in regard to driving safety, as well as driver stress relief at lowest possible costs, in order to increase the total cost effectiveness of commercial vehicles. Starting with currently implemented electronic systems up to systems now under development, a continuous development of standalone electronics up to integrated electronic compounding is the current trend. This trend shows advantages of reduced wiring and the number of sensors while it increases the function at the same time.

In particular on heavy duty commercial vehicles, the continuous braking systems “engine braking system” and “retarder”, which are independent of the service braking system, are installed to handle the continuous braking load on downhill stretches. These systems are also used to reduce lining wear and thermal loads of the service braking system. Exhaust braking systems are the most widely used form of engine braking systems. The current state-of-the-art in retarders is represented by two basic concepts, the electrodynamic retarder and the hydrodynamic retarder. A performance comparison of the different systems shows that low mountain descending speeds are the domain of engine braking systems, whereas retarders are more effective for medium and high descending speeds. The electrodynamic retarder is more favourable for lower road speeds, while the hydrodynamic retarder develops its effectiveness during higher downhill speeds.

In order to comply with the increasing demands on active safety, the commercial vehicle manufacturers have intensified the development work in the field of braking systems. The safety-relevant subsystems are “anti-lock system”, “retarder” and “engine braking system”. These systems were subject of a continuous optimization during the last years. Describing the influence of these subsystems on the steering and braking performance of commercial vehicles, it can be shown that this optimization was able to significantly increase the active safety of commercial vehicles. But it is also evident that the realized improved braking ability now demands an intelligent electronic control system which integrates the subsystems in a way that both stopping distance and vehicle stability during braking are optimized. This full-electronic braking system will lead to a further increase in safety and economy of commercial vehicles.

An alternative to the current drum brakes, with the increased requirements of todays daily service are disc brakes, in that they offer, in contrast to the drum brakes, the following technical advantages and in turn enhance the active safety of modern commercial vehicles when braking: Enhanced brake pedal-feedback and actuation Improved efficiency Little performance losses when high thermal loads occur (fading). In order to be able to determine the improvement potential of disc brakes they will be compared to the commonly employed Simplex drum brakes. Both wheel brake systems (disc-/drum brakes and all variations) were tested on a computer controlled brake dynamometer and in field tests using a heavy duty commercial vehicle (class 8). The results are compared and conclusions drawn regarding “advantages/disadvantages”.