Search Results

The traditional diesel engine suffers from high emission levels of nitrogen oxide and particulate matter. A new injection concept has therefore been developed and investigated. To enhance the air-fuel mixing process and avoid local concentration of fuel, the injection direction of each spray is varied during the injection event. This was achieved by rotating the injector. In this test, the rotational speed was 1700 rpm. On a six-cylinder engine, one cylinder was equipped with the new injector and exhaust gases were sampled with a new type of valve, integrated in the exhaust-valve stem of the affected cylinder. Tests show that the combustion is significantly affected by the rotating injection. The impact of the rotating injection on smoke, emissions and heat release was repeatable but dependent on loadpoint. No universal trend over all loadpoints was found. NO levels were mostly lowered but for smoke and CO, both lower and higher levels than without rotation were encountered.

In-cylinder flow measurements, conventional swirl measurements and CFD-simulations have been performed and then compared. The engine studied is a single cylinder version of a Scania D12 that represents a modern heavy-duty truck size engine. Bowditch type optical access and flat piston is used. The cylinder head was also measured in a steady-flow impulse torque swirl meter. From the two-dimensional flow-field, which was measured in the interval from -200° ATDC to 65° ATDC at two different positions from the cylinder head, calculations of the vorticity, turbulence and swirl were made. A maximum in swirl occurs at about 50° before TDC while the maximum vorticity and turbulence occurs somewhat later during the compression stroke. The swirl centre is also seen moving around and it does not coincide with the geometrical centre of the cylinder. The simulated flow-field shows similar behaviour as that seen in the measurements.

This paper gives a summary of image velocimetry measurements performed in a sliced diesel spray. The slicing of the spray was necessary to achieve sufficient image quality in the more dense regions of the spray. The images were double exposed to allow auto-correlation based velocimetry. The illumination was achieved with a xenon flashlight behind the spray and consequently the droplets were visible as dark shadows. Images were acquired from different points downstream from the nozzle, and a number of different radii were employed at every position. In the images the smaller droplets seem to be spherical, while the larger ones are distorted due to high weber numbers. Computer simulations indicate that large droplets may reach high weber numbers when passing through the slit, and that some of these large droplets break up.

The ignition dynamics of an ethanol-diesel direct injection compression ignition engine is investigated based on 3D RANS simulations. Experimental results of a previous test campaign on a single-cylinder research engine equipped with two direct injectors are used to validate the CFD model. Four reference engine conditions are considered, including split and overlapped injections of ethanol and diesel at low and high load. Combustion driven by the separate direct injection of pure ethanol and diesel as pilot fuel is simulated with AVL Fire and AVL Tabkin adopting the flamelet generated manifold combustion model. The in-cylinder pressure and apparent rate of heat release traces computed in the simulations are found to be consistent with the corresponding experimental results.