Search Results

Using Loop Heat Pipes (LHPs) for controlling the temperature of the source of heat has been considered for many applications. However, traditional LHPs can require significant amounts of power for source temperature control. A number of techniques have been identified and implemented to reduce control power requirements. One of the very first design approaches was to thermally couple the liquid line bringing subcooled liquid from the condenser to the vapor line entering the condenser with a number of “coupling blocks”. In another application, a variable conductance heat pipe (VCHP) was used to couple the liquid line to the LHP evaporator. A third generation approach has been developed that offers even further reductions in control power. The paper discusses earlier generations of control power reduction approaches with their advantages and disadvantages. It also describes the third generation of the approach, which is currently in manufacturing.

Loop Heat Pipe (LHP) technology has advanced to the point that LHPs are baselined for thermal control systems in spacecraft applications. Many of the applications also require redundant systems to address reliability concerns. In the redundant design, two LHPs are plumbed in parallel to the same heat source and sink. The LHPs are totally separate, and each is designed to fully accommodate the total heat load at the source if the other LHP should fail. Due to the self-regulating nature of an LHP, questions have been raised regarding the expected behavior of two LHPs operating in parallel between the same source and sink, particularly their ability to self-start and equally share the heat load. To demonstrate the application of LHPs in a redundant system, two totally independent LHPs, each with the same condenser plate and heat source, were fabricated and tested.