Search Results

It is not generally appreciated that the longitudinal position of a road vehicle model in a wind tunnel can have a significant influence on its measured aerodynamic drag. This paper explores the influence of the proximity of the end of the test section on measured aerodynamic drag, where the ‘end’ of the test section is defined by the start of the first diffuser or the end of a separate groundboard. Both flat plates and three-dimensional, automotive shapes were tested in three different model-scale and full-scale wind tunnels. It was found that the drag began to change from its upstream, undisturbed value when a vehicle model was closer than a distance of four times the square root of its base area from the end of the test section and that large changes occur when a vehicle model was closer than twice the square-root of its base area to the end of the test section. The effect is attributed to base pressure changes in the proximity of the diffuser or of the end of a groundboard.

The results of comparative aerodynamic force measurements on a full-scale notchback-type vehicle, performed between 6 European companies operating full-scale automotive wind tunnels, were published in the SAE Paper 800140. Correlation tests with the same vehicle have been extended to 2 further European and 3 North American wind tunnels. First the geometry, the design and the flow data of the different wind tunnels is compared. The facilities compared include wind tunnels with open-test-sections, closed-test-sections and one tunnel with slotted side walls. The comparison of results, especially for drag coefficients, show that the correlation between the differently designed wind tunnels is reasonable. Problems of blockage correction are briefly discussed. The comparison tests furthermore revealed that careful design of the wheel pads and blockage corrections for lift seem to be very influential in achieving reasonable lift correlations. Six-component measurements show similar problems.